• Use power tools only with specically
designated battery packs. Use of any
other battery packs may create a risk of
injury and re.
• When disposing of batteries, follow the
instructions given in the section “Disposal”.
• Do not damage/deform the battery pack
either by puncture or impact, as this may
create a risk of injury and re.
• Do not charge damaged batteries.
• Take special care of the battery. Avoid
dropping it onto any hard surface and do
not subject it to pressure or any other form
of mechanical stress. Keep the battery
away from extreme heat and cold.
• Important Danger! Never short-circuit the
battery or expose it to moisture. Do not
store it together with any metal parts
which could short-circuit the contacts.
The battery could overheat, start burning
or explode.
Under extreme conditions, battery leakage
may occur. When you notice liquid on the
batteries, proceed as follows: Carefully wipe
the liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the
instructions below.
Chargers
Your charger has been designed for a specic
voltage. Always check that the mains voltage
corresponds to the voltage on the rating plate.
WARNING:
• When not in use and before cleaning and
servicing, disconnect the battery charger
from the power supply.
• Never attempt to replace the charger unit
with a regular mains plug.
• Use your charger only to charge the bat-
tery in the appliance/tool with which it was
supplied. Other batteries could burst,
causing personal injury and damage.
• Never attempt to charge non-rechargeable
batteries.
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorized Service Centre in order to avoid
a hazard.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
• The appliance/tool/battery must be placed
in a well ventilated area when charging.
• The charger is intended for indoor use only.
CONTENTS OF PACKING
1x Lithium-ion Cordless Drill
2x Battery
1x Bitholder
1x Charger
1x Instruction manual
BEFORE USE
• Avoid damage that can be caused by
screws, nails and other elements in your
workpiece; remove them before you start
working.
• Use suitable detectors to nd hidden utility
lines or call the local utility company for
assistance (contact with electric lines can
lead to re or electrical shock; damaging a
gas line can result in an explosion; pene-
trating a water pipe will cause property
damage or an electrical shock).
• Secure the workpiece (a workpiece
clamped with clamping devices or in a
vice is held more securely than by hand).
DURING USE
• Hold power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory or fastener
may contact hidden wiring (cutting acces-
sory and fasteners contacting a “live” wire
may make exposed metal parts of the
power tool “live” and could give the opera-
tor an electric shock).
• In case of electrical or mechanical mal-
function, immediately switch off the tool or
unplug charger from power source.
BEFORE FIRST USE
Remove the machine and the accessories from
the packaging. Check the machine for trans-
port damage and do not use the machine in
case of damages. Keep the packing materials
away from children, risk of suffocation!
7062864-12V_Cordless_Drill_L-Shape-Ma-1707-13.indb 8 28-07-17 11:16
