554384
18
Zoom out
Zoom in
Previous page
1/40
Next page
EN
page 40
Asuitableomni-polar,one-wayswitchshallbeinstalledandsizedaccordingtotheabsorption
provided, with a contact opening of at least 3 mm. This switch shall be solely and exclusively
used for this purpose and installed in the immediate vicinity of the machine, installed in full
respectofthelocallaws.Alwaysturnthemachineoffviathisswitch.Thisistheonlymodel
of switch that guarantees a total electrical power disconnection.
6.2.3 Water supply connection - Characteristics
Freshwatersupplyfeatures:
Connect the machine's water supply with an interrupt valve capable of quickly and completely
shutting off water intake.
*It is compulsory to install a water-softener, in case of water with average hardness
above 8°f. Washed objects will be cleaner and the machine will last much longer.
The machine can be equipped with a water softener, on request. Ifthemachineisequipped
withawater-softener,aregenerationoftheresinsshallbedoneonregularbasis(seepar.2.6).
N.B.:Anydamagecausedbylimestone(calcareouswaterhigher-upthan8°Fandwithout
water-softener)willnotbecoveredbywarranty.
Aperiodicalcheckofthesuppliedwaterhardnessishighlyrecommended.
**The water supply temperature shall never exceed 55°C.
6.2.4 Steam evacuation
Inaccordancewithregulationsofenvironmentalhygiene,fortheproperfunctioningofthe
machine and a healthy environment for the operator who working in there, it should be at
least 10 air volume changes per hour in the room where the machine is installed.
Forsmallwashroomswerecommendatleast15airvolumechangesperhour
6.3 Installation
6.3.1 Positioning the machine
Removethepackingwithcare.
Liftthemachineasdescribedinchap.6.1.1"Handlingtheproduct".
Positionthemachineasshownontheinstallationdiagram(lay-out)approvedatthetime
of the offer.
Maintainaminimumdistanceofabout50mmfromthewalls,sothatmotorsareventilated.
Installsuctionhoodstoassureproperventilationoftheroom,inordertoeliminatesteam
and excessive humidity.
Check that the machine is properly levelled, by adjusting the legs.
Makesurethemachineisnotstandingonthepowercableoronthelling/drainhoses.
Levelthemachineat,byadjustingthesupportfeet.
Water characteristics table Min Max
StaticPressure 250Kpa 400Kpa
Dynamic Pressure 200Kpa 350Kpa
Water hardness* 2°f 8°f
Cold water-supply temperature 5°C 35°C
Hotwater-supplytemperature** 50°C 60°C
Capacity 12lt/min
Table 1
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bartscher Deltamat TF 641 LP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bartscher Deltamat TF 641 LP in the language / languages: English as an attachment in your email.

The manual is 4,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bartscher Deltamat TF 641 LP

Bartscher Deltamat TF 641 LP User Manual - German - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info