790884
10
Zoom out
Zoom in
Previous page
1/100
Next page
www.barbecook.com
10
8 GETTING THE APPLIANCE READY
FOR USE
8.1 Before each use
Each time you use the appliance, make sure that:
The appliance is in an appropriate location. See “3.3 Select
an appropriate location”.
The gas hose does not drag on the ground and cannot
come into contact with a hot surface or with dripping fat.
The bowl is clean. We recommend cleaning the bowl after
each use. See “11.2 Cleaning the bowl”.
The burners and venturis are not blocked by insect nests or
spider webs. See “11.3 Cleaning the burners and venturis”.
The burners are assembled correctly. The venturis have to
be placed over the openings of the gas valves.
lf you want to be absolutely sure that your gas connection
is okay, you can check your appliance on gas leaks
before each use. See “7 Checking for gas leaks”.
8.2 Before first use (in a long time)
lf you use the appliance for the first time or for the first time
after a long period of non-use, you have to execute some extra
checks:
Make sure that you have read, understood and checked all
the instructions in this manual (only before first use).
Check the appliance for gas leaks. See “7 Checking for gas
leaks”.
Also check for gas leaks if your appliance was assembled
by your dealer.
Clean the burners and venturis (only before first use in a
long time) . See “11.3 Cleaning the burners and venturis”.
Burn in the appliance before you put any food on it (only
before first use). See “8.3 Burning in the appliance”.
8.3 Burning in the appliance
By burning in the appliance before the first use, you remove
remaining manufacturing greases from the appliance. Proceed
as follows:
1. Light the main burners and set their control knobs to HIGH.
See “9.2 Lighting the main burners”.
2. Close the lid and let the appliance burn for 15 minutes. Do
not put any food on the grill yet.
3. After 15 minutes, open the lid and let the appliance burn for
another 5 minutes (control knobs still set to HIGH).
4. After 5 minutes, the appliance is ready for use. You can now
put food on the grill.
9 LIGHTING THE BURNERS
To light the burners with the electrical igniter, you have
to install an AA battery in the igniter. That battery is not
supplied with the appliance. You find the battery case of
the igniter on the control panel of your appliance.
9.1 Safety instructions
Before you light the appliance, execute all checks listed in
“8 Getting the appliance ready for use”.
Make sure the lid is always open when you light a burner .
Never bend directly over a burner when lighting it.
9.2 Lighting the main burners
9.2.1 using the igniter
1. Open the lid and set the control knobs of the main burners
to OFF.
2. lf no other burner is lit yet, open the gas supply and wait ten
seconds. This allows the gas to stabilize.
3. Press the igniter until you hear sparks.
4. While holding the igniter, set the control knob of the middle
burner to HIGH. Always light the middle burner first, never
try to lit all main burners at the same time.
5. lf the burner does not light after three attempts, set its
control knob to OFF, close the gas supply and wait 5
minutes. This allows any accumulated gas to escape.
6. Retry lighting the burner. lf it still does not light, try lighting
it with a match or refer to “14 Troubleshooting” to determine
the cause of the problem.
7. Once one burner is lit, light the ether burners by setting their
control knobs to HIGH.
9.2.2 using A mAtCh
1. Place a match in the match holder.
2. Open the lid and set the control knobs of the main burners
to OFF.
3. lf no other burner is lit yet, open the gas supply and wait ten
seconds. This allows the gas to stabilize.
4. Light the match and hold it about 13 mm from the burner.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Barbecook Spring 3002 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Barbecook Spring 3002 in the language / languages: All languages as an attachment in your email.

The manual is 15.33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info