503187

Barbecook BANABA GERMANY Manual

26
Zoom out
Zoom in
Previous page
1/48
Next page
26 www.barbecook.com
Ensure that:
• Thebarbecueiscorrectlyinstalled
• Thereisnoleakinthegassupply
(see‘Leakagetest’)
• Theburnersarecorrectlyinstalled,
the venturi tubes are properly placed
over the openings of the gas valves
(Fig.D),andtherearenoobstruc-
tions(seesafetyinformationand
cleaning of the burners)
• Noneofthegassupplyhosescan
comeintocontactwithahotsurface
• Yourbarbecueisinstalledinasafe
place
D
LIGHTING THE BURNERS
Prior to lighting the burners, all checks and
procedures detailed in the chapter ‘Before
the first use’ must have been carried out.
• Thelidofthebarbecuemustalways
beopenwhenyoulighttheburner(s)
• Donotbenddirectlyoverthebarbe-
cuewhenlightingtheburner(s)
• Thecontrolknobsofthebarbecue
mustbe‘OFF’.Slowlyopenthegas
cylinder valve. Before opening the
controlknobofoneburner,waitap-
prox.10secondstoallowtogasto
stabilize
• Important:firstlightthemiddle
burner
• Assoonasoneburnerhasbeen
lighted, you only need to put the con-
trolknoboftheotherburner(s)inthe
position ‘HIGH’ to light them.
• Nevertrytolightallburnersatonce
HIGH
LOW
LIGHTING THE BURNERS WITH THE
IGNITER
The battery is not supplied as standard.
• Openthelidofthebarbecue
• Openthegascylindervalve.
• Presstheigniteruntilyouhear
sparks
• Holdingdowntheigniter,pressthe
control knob of the middle burner
and turn to ‘HIGH’
• Iftheburnerdoesnotlightafter3
attempts, disconnect the gas and
wait5minutesbeforetryingagain.
Thiswillallowtheaccumulatedgas
to escape. Try again, repeating the
above steps.
• Iftheburnerstilldoesnotlight,read
the chapter ‘Troubleshooting Guide’
to determine the cause and the
remedy, or use a match as described
below.
LIGHTING THE BURNERS WITH A
MATCH
Left and right at the bottom of the burner
boxisasmallopeningthatcanbeusedto
lighttheburnerswithamatch,iftheelec-
tronicigniterdoesnotwork.(Fig.G)
• Openthelidofthebarbecue
• Placeamatchinthematchholder
provided(Fig.G)
• Holdaburningmatchthroughthe
hole,approx.13mmfromtheburner
• Openthegascylindervalve.
• Pushtherequiredcontrolknoband
turn to ‘HIGH’. The burner should
lightwithin5seconds.Ifnot,turnthe
controlknoboffandwait5minutes
toallowthegastoescape.
• Repeatsteps1through5.Ifthe
burner still does not light after 3
attempts, read the chapter ‘Trouble-
shooting Guide’
G
LIGHTING THE OTHER BURNERS
• Assoonasthefirstburnerhasbeen
lighted, you only need to put the con-
trolknoboftheotherburner(s)inthe
position ‘HIGH’ to light them.
LIGHTING THE SIDE BURNER USING
THE IGNITER
First open the lid of the side burner.
To light the side burner, use the igniter on
the control panel and the control knob on
the side table.
• Presstheigniteruntilyouhear
sparks.
• Holdingdowntheigniter,pressthe
control knob of the side burner and
turn to ‘HIGH’
• Repeatanumberoftimesifthe
burner does not light immediately.
• Iftheburnerdoesnotlightafter
5 seconds, turn the control knob to
‘OFF’andwait5minutestoallowthe
gas to escape.
• Repeatsteps1through3.Ifthe
burner still does not light, read the
chapter ‘Troubleshooting Guide’ or
useamatchasdescribedbelow.
Note:
• themaximumloadofthesideburner
is 9 kg!
• themaximumdiameterofthecook-
ing vessel is 220 mm
LIGHTING THE SIDE BURNER WITH A
MATCH
• Placeamatchinthematchholder
provided
• Holdaburningmatchapprox.
13mmfromtheburner(Fig.H)
• Pushthecontrolknoboftheside
burner and turn to ‘HIGH’. The
burnershouldlightwithin5seconds.
If not, turn the control knob ‘OFF’
andwait5minutestoallowthegas
to escape.
• Repeatsteps1through3.Ifthe
burner still does not light, read the
chapter ‘Troubleshooting Guide’ to
determine the cause and the rem-
edy.
H
VISUAL CHECK OF THE FLAMES
If the flames of the burners jump out of the
burnerboxwhenthebarbecueisinuse,
immediately turn off the control knobs. Wait
5minutestoallowthegastoescapebefore
relighting the barbecue. Read the chapter
‘Troubleshooting Guide’ if the problem
persists.
Each time you light the barbecue you
shouldchecktheflames.(Fig.I)Aproper
flameisalmostcomletelyblue,withsome
yellowatthetop.Iftheflameisabnormally
smallandforthemostpartyellow,switch
off the barbecue and check the venturi
tubes for obstructions, or read the chapter
‘Troubleshooting Guide’.
Man_BANABA_DE_BBC120808_A.indd 26 10/08/12 15:50
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Barbecook BANABA GERMANY at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Barbecook BANABA GERMANY in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 11,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info