812932
20
Zoom out
Zoom in
Previous page
1/48
Next page
6 Installation
6.1 Installation requirements
6.1.1 Requirements on the installation of the appliance in an existing fireplace
This chapter refers to the installation of the appliance in an existing open fireplace that
before was used for room heating.
Make sure that the location agrees with the safety requirements. Refer to chapter
4.1
Make sure the opening in the fireplace is large enough for a gap of 1 - 3 cm at
between the appliance and the inner fireplace walls .
Make sure the floor can support the weight of the appliance. Refer to chapter
9
for the
weight of the appliance.
Make sure that the floor temperatures in front of the appliance cannot be higher than
85 °C, during use of the appliance. Refer to chapter
5.7
.
The non-combustible floor in front of the appliance must have a width that extends at
least 150 mm from each side of the appliance and a minimum depth in front of the
appliance according the requirements in chapter
5.7
.
Make sure the room where the appliance is installed is properly ventilated.
Make sure that combustion air can flow into the appliance without obstruction.
If applicable, install a valve in the external combustion air pipe.
6.1.2 Requirements on the installation of the appliance in a new built fireplace
Important:
Make sure the floor is made of concrete or a solid pedestal of
nonflammable material.
Make sure that the floor temperatures under and in front of the appliance
are maximum 85 °C, during use of the appliance. Refer to chapter
5.3
and
chapter
5.7
.
Make sure the distance between the underside of the appliance and the
floor is minimum 1 cm.
Make sure that the location agrees with the safety requirements. Refer to chapter
4.1
.
Make sure to obey the clearances as listed in chapter
5
.
Make sure the floor can support the weight of the appliance. Refer to chapter
9
for the
weight of the appliance.
Make sure the room where the appliance is installed is properly ventilated.
Make sure that combustion air can flow into the appliance without obstruction.
If applicable, install a valve in the external combustion air pipe.
Make sure there is a 3 mm clearance on the sides and top of the appliance to allow for
expansion of the appliance during use.
Install ventilation openings near the bottom and near the top of the fireplace surround,
to avoid heat accumulation in the fireplace surround.
Make sure the total ventilation air inlet openings have a minimum area of 450 cm2. (2
inlet openings of minimum 225 2.)
Make sure the total ventilation air outlet openings have a minimum area of 450 cm2. (2
outlet openings of minimum 225 cm2.)
Installation
20 Unilux-7 45
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Barbas Unilux 7-45 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Barbas Unilux 7-45 in the language / languages: English as an attachment in your email.

The manual is 1.61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Barbas Unilux 7-45

Barbas Unilux 7-45 User Manual - English - 28 pages

Barbas Unilux 7-45 Installation Guide - German - 48 pages

Barbas Unilux 7-45 User Manual - German - 28 pages

Barbas Unilux 7-45 Installation Guide - Dutch - 48 pages

Barbas Unilux 7-45 User Manual - Dutch - 28 pages

Barbas Unilux 7-45 Installation Guide - French - 48 pages

Barbas Unilux 7-45 User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info