704939
81
Zoom out
Zoom in
Previous page
1/84
Next page
設定無線立體聲
若想設定兩個揚聲器和一個超重低音揚聲器請將
SUB – 2.1 切換為 ON。如
器,三個 PL 指示燈應起。
連接纜線......
> 若要連接到 Bang & Olufsen 系 統 ,請
B&OINPUT 切換為 YES
> 若要連到非 Bang & Olufsen  統 ,請 將
B&OINPUT 切換為 NO
> 確認音訊系統與傳輸器已切斷電源
> 將正確線的一端接到器的 PL1INPUT
(R-L) TOSLINK 輸入端一端則連接到音訊
系統正確揚聲器的輸出端。
> 將音訊系統傳輸器與揚聲器連上主電源。
器的無線狀態指示燈開始閃爍白光前方面板的
產品狀態指示燈恆亮紅色數秒後熄滅然後揚聲
器的無線狀態指示燈開始閃爍綠光。
建立無線連接......
> 短暫按下 SELECT 鈕 ,讓 傳 搜 尋 無
器。輸器的無線狀態指示燈開始閃綠色
鐘 。搜 尋 後 ,若 器 ,對
應的 PL 會亮光或白光*
1
> 住傳輸器的 SELECT 按鈕1.5秒以上以配置揚
聲 器 。最 左 邊 的 PL 狀 態 續 閃 爍 ,其 他
指示燈熄滅中一支揚聲器發出聲音
> 先,必須設定左前方揚聲器。若左前方揚聲
器 未 出 聲 ,請 SELECT 按鈕直到左前方揚
聲器發出聲音後按傳輸器上 STORE 鈕。
最左 PL 成 恆 亮 ,而 下 一 PL
狀態指示燈則開始閃爍。揚聲器發出聲音
> 在右前方揚聲器重複前個步驟接著換超重低
音揚聲器重複前個步驟最後一個 PL 狀態指
示燈開始閃爍,將自動變成恆亮表示已經
成無線。
> 如果所有揚聲器的無線連線都設定完成已連
線揚聲器的 PL 狀態指示燈會變成恆亮燈號
滅。
意 :設 PL 輸入端儲存了誤的
,可 SELECT STORE
重新配置該 PL 輸入端。
1
*如果未搜尋到任何揚聲請確認傳輸器是否閃
爍代表可搜尋的綠燈請參考揚聲器隨附指
南 並 行 重 設 ,然 後 SELECT 來搜尋無
揚聲器。
無線聲音
開啟來源後輸器與揚聲器需要幾秒鐘的時間
建立穩定的無線連接之後揚聲器便會發出聲音
若同一配置中同時設定有線與無線揚聲器...
器上的 PL 插座由左 (PL1) 至 右 入 ,最 後
重低音聲器
使用電視選單設定揚聲器距離時由於聲音會延
建議把每個無線揚聲器的距離加上3.5公尺
(11) 為設值。
左前方
(PL1 )
右前方
(PL1 )
左後方
(PL2 )
右後方
(PL2 )
左前方 右前方
左後方
(PL1 )
右後方
(PL1 )
81
傳輸器機盒與音訊系統的纜線連接範例。
全套無線揚聲器配置與前方有線揚聲器配置的範例
較。
81


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bang Olufsen Beolab Transmitter 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bang Olufsen Beolab Transmitter 1 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 11,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info