8
When you have finished the setting
up procedure, described on the
previous page, you must mount the
glass doors and the cable cover.
NOTE! Treat the glass doors with great care. If
they are cracked or chipped, or damaged in any
other way, they should be replaced immediately
as they could otherwise cause bodily harm.
You can order replacement doors through a
Bang & Olufsen retailer.
How to assemble BeoSound 3000
Mount the glass doors
The labels on the back of the glass doors
indicate which end should be pointing
upwards, and which side of the glass door
should point towards the middle of the
BeoSound 3000.
• Fasten the two glass doors, one at a time, to
the front of the BeoSound 3000 by pressing
their fastening points into the corresponding
fastening sockets on the BeoSound.
• Press gently on each of the fastening points
until you hear a click. The click indicates that
the glass doors are mounted properly.
Arrange the cables
Arrange the connector cables in the cable
cover as shown to the right. You can fasten
the cables with tape to keep them in place
before you mount the cable cover to the rear
of BeoSound 3000.
Mount the cable cover
Fasten the cover – with the cables attached –
to the grill on the BeoSound rear panel:
a Insert the bottom row of pegs into the grill.
b Push the top row of pegs into the grill.
c Pull the cable cover upwards until the pegs fit
properly with the grill.
Note: Do not plug in the cables before the cable
cover is mounted.
