658678
9
Zoom out
Zoom in
Previous page
1/26
Next page
|
9
Display installation | ZM Series User Manual
5. Place the display in the dash hole.
6. Place the guide tool on the glass of the display.
7. Slide the tool across so the drill bit hole guide lines up with the center of a screw
location hole on the case of the display.
8. Drill the pilot hole.
¼ Note: Before drilling the rest of the pilot holes it is recommended to secure the
display with at least one screw to allow for movement in the dash cutout.
9. Insert one of the supplied screws in to the screw guide and tighten using a hand
screw driver.
10. Repeat for the rest of the mounting screws.
11. Wind wing nut on to wing screw,
then wind the wing screw assembly
in to bracket till approximately 5 mm
of threaded rod protrudes through
other side of bracket.
12. Fit stopper foot on to end of wing
screw.
13. Complete for both threaded holes on
each bracket.
14. Fit brackets to rear of display, aligning
‘key holes’ on bracket with screws on
back of display case.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BandG ZM16 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BandG ZM16 in the language / languages: English as an attachment in your email.

The manual is 5,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BandG ZM16

BandG ZM16 User Manual - German - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info