658689
11
Zoom out
Zoom in
Previous page
1/52
Next page
| 9
Wiring | Zeus Glass Helm Installation Manual
Wiring
For easier access to connectors, undo the two philips screws visible on the bottom front of
the Zeus Glass Helm case, and remove the lower shroud.
Guidelines
Don’t do this: Do this:
Don’t make sharp bends in the cables Do make drip and service loops
Don’t run cables in a way that allows water to
ow down into the connectors
Do cable tie all cables to keep them secure
Don’t route the data cables in areas adjacent
to radar, transmitter, or large current carrying
cables
Do solder/crimp and insulate all wiring
connections, if extending or shortening
power or NMEA 0183 cables
Do leave room at the back to install and
remove cables
!
Warning: Before starting the installation, be sure to turn electrical power o . If power is
left on or turned on during the installation,  re, electrical shock, or other serious injury may
occur. Be sure that the voltage of the power supply is compatible with the Zeus Glass Helm
!
Warning: The positive supply wire (red) should always be connected to (+) DC with
the supplied fuse or a circuit breaker (closest available to fuse rating).
Power connection
The Zeus Glass Helm can be powered by either
12 V or 24 V DC. They are protected against reverse
polarity, under voltage and over voltage (for a
limited duration).
The supplied power cable has four cores used for:
power into the system (Red and Black wires)
controlling power state of the display or power
state of other displays and devices (Yellow wire)
connecting to an external alarm (Blue wire)
Connect Red to (+) DC using a 3 amp fuse.
Connect Black to (-) DC. The processor can be
powered on and o using the power button on
the front of the case.
Power Control connection (yellow wire)
Planning is required how you want to be able to turn on and o the Zeus Glass Helm and
connected compatible devices.
The yellow Power Control wire on the Zeus Glass Helm processor power cable can either
be an input that will turn on the processor when power is applied, or an output that turns
on other devices when the processor is powered on. It can be con gured at the installation
stage to control the power state of displays and compatible devices. When commissioning
the system, the Zeus Glass Helm can be set to be a Power Control Slave or Power Control
Master.
Power Control con guration options of the Zeus Glass Helm are:
use the Power button on case or ZC1 to turn on the processor only: Yellow wire not
connected
Zeus Glass Helm processor to turn on when power is applied: Common red and yellow wires
use the Power button on processor case or ZC1 to turn on the processor and other Zeus
Glass Helm processors and or compatible devices such as Broadband Radar: Yellow wire
connected to a Power Control Bus. (Set one or more displays to be a Power Control Master)
3
+
_
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BandG Zeus2 Glass Helm at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BandG Zeus2 Glass Helm in the language / languages: English as an attachment in your email.

The manual is 6,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BandG Zeus2 Glass Helm

BandG Zeus2 Glass Helm User Manual - English - 136 pages

BandG Zeus2 Glass Helm User Manual - German - 115 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info