658717
84
Zoom out
Zoom in
Previous page
1/102
Next page
82
Setting the Module Address
When adding any module to the network you will need to allocate a unique address to that module so that it can
be referenced with the WTP.
To set the address there are 8 dip switches inside the module located between the two terminals as shown
below. As default all of these switches are set to the ‘OFF’ position, making the address code zero.
The address allocation switches work on a binary code system where:-
Switch 1 = 1
Switch 2 = 2
Switch 3 = 4
Switch 4 = 8
Note: Only switches 1 to 4 are used to set the module address. Switches 5 to 8 are not used and should be left in the
‘OFF’ position at all times.
Binary Code Example
1 2 4 8 Binary Value
The address is set by moving a combination of switches and adding the binary value of each switch in the ‘ON’
position together. This binary code system makes it possible to set a total of 16 address codes 0 to 15.
The example above shows switches 1, 4 and 8 in the ‘ON’ position. So the binary total will be 1+4+8 = 13
This would set the address to 13.
Note: Each module must have a unique address allocated to it.
Module Hot-Swap
If any changes are required on the system it is recommended that the system power is turned o. However, if
necessary, sensor interfaces can be replaced while the system is powered on. If replacing a module ensure that
you set the address of the new module to match the unit being replaced, then the system will not require any
re-conguration.
84


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BandG WTP3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BandG WTP3 in the language / languages: English as an attachment in your email.

The manual is 7,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info