658717
77
Zoom out
Zoom in
Previous page
1/102
Next page
75
WTP3 Module
Step 1: Find a suitable location to position the module.
Mount the module vertically. Ensure that there is at least 100mm clearance between the connector and grommet
and any surface to enable easy access to cables
Step 2: Mark the hole positions, drill pilot holes and x into position with 2 self tapping screws
Ross Howard 2010
Step 3: To remove the lid, unscrew the 2 lid screws.
Note: The lid hinges at the bottom edge of the module.
To close the lid you need to locate the bottom edge
rst.
Step 4: Cut the grommet indicated to a length that
creates a tight t for the cable to be fed. Feed the cable
through and wire into the module plug.
Ensure the cables are positioned to the left of the centre
pillar and the plug can reach the connectors without
placing tension on the wires
77


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BandG WTP3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BandG WTP3 in the language / languages: English as an attachment in your email.

The manual is 7,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info