Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,834 b2,
Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
Basic Installation and
Confi guration Guidelines
Use minimum 6AWG copper conductors only.
Torque fi eld connections between 21 and 23 in lbs.
Readily accessible disconnecting means to be provided at time of instal-
lation.
Permanently connected power supply.
Connect only to a circuit protected by a Class A Ground Fault Circuit Inter-
rupter (GFCI) or Residual Current Device (RCD) mounted at least 5’ (1.52M)
from the inside walls of the spa/hot tub and in line of sight from the
equipment compartment.
CSA enclosure: Type 2
Refer to Wiring Diagram inside the cover of the control enclosure.
Refer to Installation and Safety Instructions provided by the spa manufac-
turer.
Warning: People with infectious diseases should not use a spa or hot
tub.
Warning: To avoid injury, exercise care when entering or exiting the spa
or hot tub.
Warning: Do not use a spa or hot tub immediately following strenuous
exercise.
Warning: Prolonged immersion in a spa or hot tub may be injurious to
your health.
Warning: Maintain water chemistry in accordance with the Manufactur-
ers instructions.
Warning: The equipment and controls shall be located not less than 1.5
meters horizontally from the spa or hot tub.
Warning! GFCI or RCD Protection.
The Owner should test and reset the GFCI or RCD on a
regular basis to verify its function.
CSA Compliance/Conformité
Caution:
• Test the ground fault circuit interrupter before each use of the spa.
• Read the instruction manual.
• Adequate drainage must be provided if the equipment is to be installed
in a pit.
• For use only within an enclosure rated CSA Enclosure 3.
• Connect only to a circuit protected by a Class A ground fault circuit
interrupter or residual current device.
• To ensure continued protection against shock hazard, use only identical
replacement parts when servicing.
• Install a suitably rated suction guard to match the maximum fl ow rate
marked.
Warning:
• Water temperature in excess of 38°C may be injurious to your health.
• Disconnect the electrical power before servicing.
Attention:
• Toujours verifi er l’effi cacite du disjoncteur differentiel avant d’utiliser
differentiel avant d’utiliser le bain.
• Lire la notice technique.
• Lorsque l’appareillage est installe dans une fosse, on doit assurer un
drainage adequat.
• Employer uniquement a l’interieur d’une cloture CSA Enclosure 3.
• Connecter uniquement a un circuit protege par un disjoncteur differen-
tiel de Class A.
• Afi n d’assurer une protection permanente contre le danger de shock
electrique, lors de l’entretien employer seulement des pieces de rechange
identiques.
• Les prises d’aspiration doivent etre equipees de grilles convenant au
debit maximal indique.
Avertissement:
• Des temperatures de l’eau superieures a 38°C peuvent presenter un
danger pour la sante.
• Deconnecter du circuit d’alimentation electrique avante l’entretien.
Warning/Advertissement:
• Disconnect the electric power before servicing. Keep access door closed.
• Deconnecter du circuit d’alimentation electrique avant l’entretien.
Garder la porte fermer.
Warning! Qualifi ed Technician Required for Service and Installation
Warning! Shock Hazard!
No User Serviceable Parts.
Do not attempt service of this control system. Contact your
dealer or service organization for assistance. Follow all
owner’s manual power connection instructions. Installation
must be performed by a licensed electrician and all ground-
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Balboa TP800 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Balboa TP800 in the language / languages: English as an attachment in your email.
The manual is 0,27 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
