784764
18
Zoom out
Zoom in
Previous page
1/35
Next page
Circulation Pump Modes
If the system is equipped with a circulation pump, it will
beconguredtoworkinoneofthreedifferentways:
1. The circulation pump operates continuously (24
hours)withtheexceptionofturningofffor30minutes
at a time when the water temperature reaches 3°F
(1.5°C) above the set temperature (most likely to
happen in very hot climates).
2. The circulation pump stays on continuously,
regardless of water temperature.
3. A programmable circulation pump will come on
when the system is checking temperature (polling),
duringltercycles,duringfreezeconditions,orwhen
another pump is on.
ThespecicCirculationModethatisusedhasbeen
determined by the Manufacturer and cannot be
changedintheeld.
Filtration and Ozone
If a spa does not have a circulation pump, Pump 1
lowandtheozonegeneratorwillrunduringltration.
On circ systems, the ozone will generally run with the
circulationpump,butcanbelimitedtoltrationcycles.
(On some circ systems, Pump 1 low will run along with
thecirculationpumpduringltration.)
Mostsystemsarefactory-programmedwithonelter
cycle that will run in the evening (assuming the time-
of-day is properly set) when energy rates are often
lower.Theltertimeanddurationareprogrammable.
Asecondltercyclecanbeenabledasneeded.Atthe
startofeachltercycle,thewaterdeviceslikeblower,
misterdevice(iftheseexist)andotherpumpswillrun
brieytopurgetheplumbingtomaintaingood
water quality.
Freeze Protection
If the temperature sensors within the heater detect
a low enough temperature, then the water devices
automatically activate to provide freeze protection.
The water devices will run either continuously or
periodically depending on conditions. In colder
climates, an optional freeze sensor may be added
to protect against freeze conditions that may not be
sensedbythestandardsensors.Auxiliaryfreezesensor
protectionactssimilarlyexceptwiththetemperature
thresholds determined by the switch. See your dealer
for details.
Clean-up Cycle (optional)
When a pump or blower is turned on by a button press,
a clean-up cycle begins 30 minutes after the pump
or blower is turned off or times out. The pump and
the ozone generator will run for 30 minutes or more,
depending on the system. On some systems, you can
change this setting.
Clean-upcyclesallowthespatolterlesswhenthespa
isusedlessoften,andtoltermorewhenthespais
used more often.
spaTouch 3 User Guide
42344_Rev D 18
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Balboa SpaTouch3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Balboa SpaTouch3 in the language / languages: English as an attachment in your email.

The manual is 10.53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info