Installation instructions
Before reading these instructions, please
unfold the pages with the illustrations.
Installation
• Install your combined
freezer-refrigerator in a dry, well
ventilated room. In a damp room the
moisture in the air will form
condensation on the outside of the
appliance.
• If the unit is placed next to a heat
source or another refrigerator, then the
following minimun lateral clearances
must be maintained (or an insulating
panel used):
from electric cookers 3 cm.
from oil or coal-fired cookers 30 cm.
from other refrigerators 2 cm.
• Since warm air generated at the back of
the refrigerator must be allowed to
escape unhindered, you must never
block the space between it and the wall
nor cover the ventilation grid at the
base.
• The appliance must stand firm and
level. To compensate for any
uneveness in the floor set the ajustable
feet at the front, fig s. Two rollers
underneath the appliance allow it to be
easily positioned in a niche.
Electrical connection
• The refrigerator must be connected to a
220-240 V (SN/N), 220-230 V (ST) AC
(50 Hz) supply only, and must be
protected by a 13 Amp fuse. The
connection must be made via a properly
installed socket with a non-fused
earthing contact.
Changing the opening
direction of the doors
Fig. q
• Take off the strip (1) by removing the
screws (2) and then pulling it upwards.
• Unscrew the upper hinge (3) and
remove the freezer compartment door (5).
• Unscrew the centre hinge (6) and
remove the refrigerator door (7).
• Remove the plastic plugs (8) (two pieces)
from the opposite side, and press
them into the holes left by the centre
hinge once it has been removed.
• Remove the protective cover (9).
• Unscrew the lower hinge pin (10) and fix
it on the opposite side.
• Fit the refrigerator door (7) without
forgetting the separator (11), and screw the
centre hinge on.
• Fit the freezer compartment door (5)
without forgetting the adjusting washer (12).
• Fix the upper hinge (3) onto the
opposite side and then unscrew the hinge
pin (4) and fit it into the other
threaded hole, without forgetting to fit the
door separator (13).
• Screw the strip (1) back on (2).
• On some models the door handles (14)
must also be changed to the opposite side.
Our contribution towards a cleaner
environment - we use recycled paper.
13
EN
