E852XE BEARD AND
MOUSTACHE TRIMMER
1. 1 cutting guide for 74 lengths
(from 0.4mm to 15mm, in
0.2mm increments)
(special ‘3-day beard’ cutting
guide)
2. 32mm blade
Moveable blade:
- Exclusive three-dimensional
etching process: for an
exceptionally sharp cutting
edge.
- CMS (Chrome-Molybdenum-
Stainless Steel): ultra-
hardwearing and 100% stainless
steel blade.
Fixed Blade:
- TITANIUM coating: for
increased longevity
These 2 technologies provide a
perfect surface condition and
combining them is ideal for
reducing the friction coecient.
3. 1 shaving head with its wide
Nickel grid (38mm) and its 28
extremely sharp blades
4. ON/OFF button
5. LCD screen that displays:
6. Selected length in mm
7. Battery charge level
8. Cutting length setting
9. Plug for use on the mains and
for charging
10. Cleaning brush
IMPORTANT INFORMATION
REGARDING THE NI-MH
BATTERIES OF THIS UNIT
To obtain and maintain the
longest battery autonomy
possible, allow it to charge
for 16 hours before using it
for the rst time and then
approximately every three
months. Full autonomy of
the unit will only be obtained
after three complete recharge
cycles.
CHARGING THE TRIMMER
1. Plug the cord into the unit
and connect the transformer.
Before using the trimmer for
the rst time, allow it to charge
for 16 hours. Make sure the
trimmer’s switch is in the OFF
position.
2. The LCD screen will light up
and a battery icon with a bar
will indicate the battery charge
level.
3. A full charge provides a
minimum of 30 minutes’ use of
the trimmer.
4. Allow 90 minutes for
recharging.
USE ON THE MAINS
To use the trimmer on the mains,
plug the cord directly into the
unit.
Plug the trimmer, in the OFF
position, into the mains and
switch ON (If the battery is very
weak, wait about 1 minute).
IMPORTANT! Use only the
transformer provided with the
trimmer Ref. E852XE Voltage =
3.6V – 1000mA. (Fig. 1)
ENGLISH