661364
267
Zoom out
Zoom in
Previous page
1/316
Next page
APPENDIX
265
7
Installing the needle plate spacer
Attach the needle plate spacer to the needle plate.
1 Needle plate spacer
Preparing the mounting jig
Attach the mounting jig to a stable surface, such as a
desk.
a
Loosen the thumb screw for the mounting
jig to open the mounting bracket so that it is
wider than the thickness of the mounting
surface.
The mounting bracket can be mounted onto a
mounting surface with a thickness from 9 mm (3/8
inch) to 38 mm (1-1/2 inches).
b
Securely clamp the mounting bracket onto
the mounting surface by tightening the
thumb screw.
1 Mounting bracket
2 Mounting surface
3 Tighten thumb screw
c
Check that there is no looseness.
If there is looseness, mount the mounting jig onto the
mounting surface again.
d
Adjust the size of the mounting jig
according to the type (size) of cap being
embroidered.
1 Low Profile (shorter caps)
2 Standard type (taller caps)
Memo
If there is a gap between the clamp of the
thumb screw and the mounting surface,
insert the included pad as shown below.
1 Mounting bracket
2 Mounting surface (worktable, desk, etc.)
3 Pad
4 Thumb screw
Note
Be sure that the mounting bracket is
securely clamped onto the mounting
surface and that the thumb screw is firmly
tightened.
Do not attach the mounting jig to an
unstable surface (flexible, bent or warped).
Be careful that the mounting jig does not fall
when it is removed.
267


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Baby Lock Valiant - BMV10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Baby Lock Valiant - BMV10 in the language / languages: English as an attachment in your email.

The manual is 15,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Baby Lock Valiant - BMV10

Baby Lock Valiant - BMV10 Additional guide - English - 1 pages

Baby Lock Valiant - BMV10 Additional guide - English, French, Spanish - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info