661214

Baby Lock Ovation - BLES8 Manual

81
Zoom out
Zoom in
Previous page
1/92
Next page
1. Open the front cover and cutting blade cover then raise the
presser foot.
2. At the threading port, clip the looper thread that is to be
replaced. (fig.A) Remove thread from under the presser foot
and the upper thread guides. Replace cone of thread with
specialty thread.
3. With the threading lever engaged in the threading position (fig.
B) turn handwheel toward you to close looper tubes. (fig. C)
4. Thread specialty thread into the upper thread guides, leaving
an 18 inch (40cm) tail above the threading port. (fig.D)
5. Cut a 24 inch (55cm) strand of serger thread and fold in half to
form a thread cradle. Insert the loose ends of the thread cradle
into the port about 1 inch (2.5cm).
6. Holding the cradle loop with left hand, push the threading
button with your right hand (fig.E) until the thread ends come
out the looper eye. For chain looper, open side door of machine
to make sure thread is laying inside the tray.
7. Insert the specialty thread tail into the cradle loop (fig.F), pull
the serger thread ends until the specialty thread comes through
the looper eye. (fig.G) Discard or set aside the thread cradle.
8. Place upper looper thread under the foot and to the left, cut
lower looper thread to 4 inches (10cm) and leave it hanging
loose. Cut chain looper thread 4 inches (10cm) and place in
tray.(fig. H)
Close side door, cutting blade cover and front cover of machine.
S
P
E
C
I
A
L
T
Y
T
H
R
E
A
D
S
79
Thread Cradle for Loopers
A
B
C
D
E
F
G
H
… 81 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Baby Lock Ovation - BLES8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Baby Lock Ovation - BLES8 in the language / languages: English as an attachment in your email.

The manual is 10,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info