Manual Axkid Move (page 17 of 117) (English, German, Danish, French, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish)

767999

Zoom out

Zoom in

1/117

Open the belt lock-o clips (M) on both sides of the Move child restraint. Fully lengthen the seat

belt until the lap section of the belt is at least 70-80cm (27-32 inches) long. Feed the seat belt

through the seat belt slot (D), between the seat cover and seat body until the belt comes out

through the seat belt slot on the other side. If you prefer, you can instead feed the seat belt through the

seat belt slot (D), then over the top of the seat cover and then through the seat belt slot on the other

side.

Insert the seat belt tongue into the vehicle’s seat belt buckle. Pull the seat belt until all slack is

removed along the seat belt route. Secure both the lap and shoulder belt in the lock-o closest

to the vehicle’s seat belt buckle.

In the lock-o on the opposite side, only the lap belt should be secured.

Fastening the vehicle seat belt

Unclip the tether straps from the child restraint.

Press the grey button (N) and pull the loop end out to maximise the length of the strap.

To attach the tether straps to an anchor point, wrap the strap around the chosen anchor point

and pass the metal clip through the loop.

When installing the Move on a back seat, wrap the tether straps through either the rear of the

front seat rails (i), or the hinge of the front seat (ii).

When installing the Move in the front passenger seat, the tether straps should be wrapped

around the nearest suitable anchor point (i) that will allow the straps to be tightened fully.

Anchor points set further back (ii) can be used and if need be the straps can be crossed over

(iii) and even looped together (iv).

Reattach the metal clips to each side of the child restraint and pull the free ends of both tether

straps until you have tensioned them. Pull each strap once again as hard as possible to ensure

the child restraint is secured tightly.

Unfold the support leg (Q) out to its maximum angle. Press the leg extension button (R) and extend the

support leg until it reaches the ﬂoor.

Note: The support leg belt may, but does not need, to be fully tensioned.

It is important that you check that the support leg is at an angle over 10° from the back of the

seat. You could check this by ensuring that the support leg is further away from the seat than

the vertical line.

Attaching the tether straps

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Axkid Move in the language / languages: English, German, Danish, French, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1,47 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Axkid Move Manual

Product: