559560
17
Zoom out
Zoom in
Previous page
1/55
Next page
17
2 Hardware Installation
2. Connecting the ISDN-Controller T1 to the NTPMKU
or NTPMGF (NTs with T-shaped mounting plate)
Examine your NT and determine which type it is. In case
of doubt, contact your ISDN operator’s technical ser-
vice.
When errors and malfunctions occur at the NT, the S
2M
interface may no longer synchronize with the local
switch. In this case the switch temporarily disables
the PRI. This is indicated by a red LED on the NT.
Newer local switches re-enable the interface again
automatically.
Such synchronization errors may occur during the
AVM ISDN-Controller T1/T1-B connection proce-
dure. If the line is not automatically re-enabled,
contact your ISDN operator’s technical service.
2.3.1 Connection to the NTPM (NT with Terminal
Board)
To ensure that the S
2M
interface remains synchro-
nized with the local switch when no terminal equip-
ment is connected, the is NT usually outfitted with wire
jumpers between terminals S2M ab/a and S2M ab/b,
and between terminals S2M an/a and S2M an/b (“an”
= in; “ab” = out). These jumpers must not be removed
until the terminal equipment—in this case, the AVM
ISDN-Controller T1/T1-B—is operational, i.e. its
driver software has been loaded.
1. Connect the 9-pin sub-D connector of the cable to
the 9-pin socket of the AVM ISDN-Controller
T1/T1-B (see Fig. 3 in Appendix B, Illustrations).
Secure the connection by tightening the finger
screws. Route the 6 meter cable as directly as
possible to the NT.
2. Unlock and remove the cover of the NTPM’s
connection terminals.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AVM ISDN-Controller T1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AVM ISDN-Controller T1 in the language / languages: English as an attachment in your email.

The manual is 0,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of AVM ISDN-Controller T1

AVM ISDN-Controller T1 User Manual - German - 74 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info