651056
45
Zoom out
Zoom in
Previous page
1/176
Next page
45
HOW TO INSTALL YOUR WINE CELLAR
INSTALLATION AREA
Be sure to install it in a suitable spot: far away from any heat source, protected from sunshine, not exposed
to low temperatures. This way you will obtain the best operating conditions for the lowest energy
consumption.
Also make sure that the surface area where the cabinet will be installed is flat and resistant (weight of the
device plus its load; a 75 cl wine bottle generally weighs 1.3 kg).
Do not place it in the open air and be careful to maintain a minimum space of 200 mm between the top of
the cabinet and the ceiling located above it.
Note: the defrosting water recovery tank located at the back of the cabinet near the compressor could
overflow under extreme ambient conditions.
For this reason, we recommend choosing the appropriate kind of wall and floor surfaces in the
device's installation area so that humidity or the possible formation of water does not cause any
damage.
CONNECTION TO THE ELECTRICAL POWER NETWORK
Be sure to read and understand the safety instructions indicated at the beginning of this guide.
If the wine cabinet was tilted very much during its transport or placement, it is important to leave the wine
cellar in the vertical position for 24 hours before connecting it so that the lubricating oil can descend and
accumulate in the compressor.
Otherwise, the cooling system could completely break down.
Refer to the safety instructions mentioned at the beginning of this guide !
Your wine cellar is equipped with a connecting cable and a power plug for a 230 V/50 Hz single phase
power network (CE standard). It must be connected to an earthed wall outlet with a minimum protection of
10 A.
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Avintage DVA265PA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Avintage DVA265PA in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 6,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info