765059
7
Zoom out
Zoom in
Previous page
1/21
Next page
1312
OP1-20-GB(V3) OP1-20-GB(V3)
PART8-TROUBLE SHOOTING
Repair Patch Instructions
(Small pinhole and small puncture leaks can be repaired with the included repair patch)
a) Locate the leak place.
b) Deate the air.
c) Clean the area surrounding the leakage and wipe up all water from the surface.
d) Take out the repair patch, cut it into required shape and size, which should be larger than the leaking area, put the patch
on leaking area and press tightly.
e) Wait 30 minutes for open-air drying of the repaired position.
If the damage is too big, we recommend using a Silicone or rubber based glue for repair.
Repair Glue Instructions
1 Locate the leak place.
2 Deate(if necessary),and drain thoroughly
3 Clean the area surrounding the leakage and wipe up all water from the surface.
4 Thoroughly clean the area surrounding the leak .Cut a piece of repair material in round shape, which should be larger than
the damaged area.
5 Gluing (need to purchase adhesive separately) one side of the material patch to the repair area. Please notice the material
patch need to be applied glue evenly.
6 Put the patch on the damaged area and press tightly. Wait 12 hours for drying. After patch has dried, apply glue around the
edges for a complete seal (dry 4 hours) swimming pool storage.
PART9-LIMITED WARRANTY
If any of the components have been consumer-replaced, damaged, or misused, the corresponding warranty on those compo-
nents is invalidated. In this situation, you will be advised of the cost of replacement parts and processing instructions.
If a veriable manufacturing defect is found during the relevant time period, we agree to repair or replace at its option any
product under warranty provided proper proof of purchase is presented.
This limited warranty is not valid if the product is used for commercial purposes, or if the damage is caused by an accident, an
act of God, consumer misuse, neglect or abuse, vandalism, improper use of chemicals, exposure to extreme weather condi-
tions or negligence during product set up or disassembly.
We cannot be held responsible for the cost of installation, labor, or transportation expenses incurred due to the replacement of
defective parts. This limited warranty, furthermore, does not cover any unauthorized alterations to the product.
PROBLEM DESCRIPTION CAUSE REMEDY
FILLED
POOL
IS NOT
ROUND
• Pool has taken on an oval, rectan-
gular or “egg-like” shape.
• Pool appears to slope to one side
or pool water depth is uneven.
• Wrinkles in bottom of liner were
not adequately smoothed out prior
to filling.
• Side walls were not properly
“pushed out” as pool was filled,
causing circumference of top ring
to be outside that of the pool's side
walls.
• Pool is resting on bumpy or slop-
ing ground.
• Drain pool to a 1” water depth and
then smooth out as many wrinkles
as possible.
• Drain pool to a 1” water depth and
then push out side walls until they
are outside of the circumference of
the top ring.
• Make sure ground underneath
pool is very flat, level and free of
any mounds of soil.
COLORED
WATER
• Water turns blue, brown, or black
when first treated with chlorine.
• The chlorine is oxidizing minerals
in your water. This commonly occurs
with water from different sources.
Adjust pH to recommended level.
• Run filter until water is clear.
• Regularly clean cartridge.
PARTICALS
SUSPENDED
IN WATER
• Water looks “milky” or cloudy.
• “Hard Water” caused by an elevat-
ed pH.
• Chlorination is inadequate.
• Foreign debris in water.
• Bathers are not cleaning their feet
prior to entering pool.
Adjust pH. Check with a swimming
pool supply retailer for correct water
treatment.
• Ensure proper chlorine level.
• Clean or replace your filter.
• Spray off dirt with a high-pressure
hose before entry.
PERSISTENT
LOW WATER
LEVEL
• Pool appears to be losing water on
a daily basis.
• Tear or hole in pool liner.
• Tear or hole in a filter pump hose.
• Hose clamps are too loose.
• Evaporation from high summer
temperatures.
• Locate damage and repair with the
included patch kit.
• Repair or replace hoses.
• Tighten all hose clamps.
• Keep pool covered when not in
use.
ALGAE
• Water has greenish tint.
• Green, brown or black spots
appear on pool liner.
• Pool bottom is slippery and/or an
unpleasant odor is present.
Algae is present.
• Apply “shock” treatment (super-
chlorinator). Check pH and adjust to
an appropriate level per your local
pool supply retailer.
• Vacuum or lightly scrub pool liner.
• Test water often to maintain proper
chlorine levels.
POOL
WATER
IS COOL
• Water is not warming to a comfort-
able swimming temperature.
• Pool was set up in an excessively
shady or tree lined area.
• Heat is escaping from pool water.
• Relocate pool to a more open
location where it can get maximum
exposure to sunlight during peak
daylight hours.
• Keep your pool covered whenever
it is not in use.
PART8-TROUBLE SHOOTING
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Avenli 17797 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Avenli 17797 in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 2,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info