625221
24
Zoom out
Zoom in
Previous page
1/32
Next page
The purpose of the I/M Readiness Monitor Status is to indicate which of
the vehicle's Monitors have run and completed their diagnosis and
testing (as described in 2.5), and which ones have not yet run and
completed testing and diagnosis of their designated sections of the
vehicle's emissions system.
The I/M Readiness Monitor Status function also can be used (after repair
of a fault has been performed) to confirm that the repair has been
performed correctly, and/or to check for Monitor Run Status.
Select [I/M Readiness Test] and Press [ENTER], the screen will display
the interface as shown below:
Press return to the .EXIT Diagnostic Menu
23
Diagnostic Menu
Erase Codes
View Data
View Freeze Frame
I/M Readiness
Read Codes
O2 Monitor Test
4.6 O2 Sensor Test
OBD II regulations set by the SAE require that relevant vehicles monitor
and test the oxygen (O2) sensors to identify problems related to fuel
efficiency and vehicle emissions. These tests are not on-demand tests and
they are done automatically when engine operating conditions are within
specified limits. These test results are saved in the on-board computer's
memory.
The O2 Sensor Test function allows retrieval and viewing of O2 sensor
monitor test results for the most recently performed tests from the
vehicle's on-board computer.
The O2 Sensor Test function is not supported by vehicles which
communicate using a controller area network (CAN). For O2 Sensor Test
results of CAN-equipped vehicles, see chapter "On-Board Mon. Test".
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AutoPhix OM510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AutoPhix OM510 in the language / languages: English as an attachment in your email.

The manual is 0,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info