701400
13
Zoom out
Zoom in
Previous page
1/16
Next page
13
FUNCTIONAL INSTRUCTIONS
7
8
6
9
If the POWER LED lights up blue, the sound system is ready for operation. If the POWER LED lights up red refer to the chapter
TROUBLE SHOOTING on page 15.
The REMOTE jack is for connecting the enclosed bass remote. With this controller you are able to adjust the bass level e.g. out
of the driver’s seat. If the bass remote is connected, the OUTPUT LEVEL controller (#1) is without function.
Connect the enclosed wiring harness into AUDIO INPUT and connect the die RCA with RCA cables to your head unit. If your
head unit is not equipped with pre-amplier outputs, you can use its speaker output cables as input signal. Then set the switch
INPUT LEVEL to position HIGH.
Cut the cables of the enclosed wiring harness with RCA jacks and connect the four loose ends with the speaker outputs of your
head unit as following:
WHITE L+
WHITE-BLACK L-
GRAY R+
GRAY-BLACK R-
The AUTO TURN ON switch determines the way how the sound system will be turned on. If you want to turn on the sound sys-
tem with the remote cable of the head unit and it‘s connected as described on page 5 Section #2, the switch must be in position
REM. If you need to switch the sound system automatically because your head unit does not have a remote cable, you can set
the switch AUTO TURN ON to DC OFFSET or AUTO.
By the so called DC OFFSET function the amplier detacts a voltage increase to 6 volts on the high level speaker outputs and
turns on and the amplier automatically. As soon as the head unit is turned off, the amplier shuts down automatically.
The DC OFFSET function usually works with 90% of all headunits, because they are equipped with the ”High Power” outputs.
Only with a few older headunits the AUTO TURN ON function is not applicable. Then use the switch position AUTO, which turns
the amplier on and off with a little delay.
IMPORTANT: The AUTO TURN ON function works only with high level input operation. Refer to #5 and #9.
CUT
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Autek A690RXA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Autek A690RXA in the language / languages: English, German as an attachment in your email.

The manual is 2,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info