Manual Austria Email EWH serie (page 35 of 36) (English, German)

800549

Zoom out

Zoom in

1/36

7. All warranty claims shall expire in the event of unauthorised third party interventions, even if these are carried out by a

licensed installer. The acceptance of costs arising from repairs carried out by third-parties shall be subject to the PM having

been requested to x the fault and having either failed to meet their exchange or repair obligations or not having done so

within a reasonable period.

8. The guarantee period shall neither be renewed nor extended as a result of the services in response to claims under

the guarantee or warranty, or service and maintenance work.

9. Transport damage shall only be inspected and perhaps recognised if these are reported to the PM in writing within

one working day of delivery.

10. To the extent permissible by law, any claims over and above provisions made in the guarantee, such as in particu-

lar those relating to compensation for damages and consequential losses, are excluded. Pro-rata labour hours for

repairs, as well as the costs of restoring the system to its original condition must be paid by the customer at the full

rate. The guarantee oered shall only cover the repair or replacement of this device in accordance with this guaran-

tee statement. The provisions of the PM‘s sales and delivery conditions shall continue to apply in full provided that

they are not modied through these guarantee conditions.

11. Services not provided within the framework of these guarantee conditions shall be invoiced to the customer.

12. A precondition for the fullment of these guarantee provisions by the PM is that, on the one hand the device has

been fully paid for and, on the other hand, that the claimant has fully complied with all of his obligations towards

the reseller.

13. A guarantee shall be provided for the enamelled internal boiler for water heaters, with no diminution of the guaran-

tee provisions in accordance with Points 1 to 12 for the period oered following delivery. If the guarantee conditions

are not met then the legal warranty conditions of the country to which the goods have been delivered shall apply.

14. For the attainment of claims in accordance with Austrian product liability legislation, it should be noted that:

Any possible claims from the product liability stated above which deal with damage caused by a failure of a product

(e.g. a person receives bodily injury, health is damaged or some other bodily part is damaged by the product), are

only justied when all the prescribed measures and requirements which are needed for error-free and standard

compliant operation of the device have been fullled. This includes for example the mandatory and documented

replacement of the anode, connection to the correct operating voltage, damages arising from improper operation

are to be avoided etc. These provisions are to be derived from the fact that, had all instructions been complied with

(standards, installation and operating instructions, general guidelines etc.) the fault in the device or product that

caused the secondary damages would not have arisen. Furthermore, it is indispensable that the necessary docu-

mentation, such as for example the designation and manufacturer number of the storage tank, the seller‘s invoice

and the concessionaire who performed the sale as well as a description of the fault are submitted for the inspection

of the allegedly faulty storage tank in the technical laboratory (absolutely necessary as a trained professional will in-

spect the storage tank and analyse the cause of the fault). To avoid any confusion regarding the storage tank during

transportation, it must be provided with a clearly legible label (preferably with the address and signature of the end

user). Furthermore, the original installation at the place of assembly may not be changed, converted or dismantled

before being inspected by the manufacturer or an appointed expert.

Any change to the original assembly situation on-site will lead to the immediate exclusion of any claims arising from

the warranty, guarantee or product liability.

A corresponding photographic record is required showing the extent of the damage, the installation details (cold

water input, hot water output, heater ow and/or back-ow, safety ttings, and, if applicable, expansion vessel) as

well as the faulty area of the storage tank. In addition the PM expressly reserves the right to demand the provision

of any documentation, the device or device components by the customer deemed necessary to clarify the situation.

A prerequisite for the performance of services under the heading, Product Liability, is that it is incumbent upon the

damaged party to prove that the damage was caused by a product of the PM. Claims made in line with the Austrian

Product Liability Act are only valid for the sums above the rst EUR 500 (excess). Until such time as the entire si-

tuation and circumstances have been claried as well as until such time as the cause that resulted in the damages

has been clearly identied, the PM decidedly rejects any potential culpability. Failure to follow the operating and

assembly instructions as well as the relevant standards is considered negligence and shall leads to a liability exclu-

sion in the eld of compensation for damage.

The illustrations and data are not binding and may be modied without notice when technical improvements are made.

Subject to printing errors and technical changes.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Austria Email EWH serie in the language / languages: English, German as an attachment in your email.

The manual is 2.08 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Austria Email EWH serie Manual

Product: