800546

Austria Email EKF series Manual

35
Zoom out
Zoom in
Previous page
1/36
Next page
35
Id.Nr.: 123158-19
WARRANTY, GUARANTEE AND PRODUCT LIABILITY
Warranty is made according to the legal provisions of the Republic of Austria and the EU.
1. A condition for the operation of guarantee services by the product manufacturer (hereinafter referred to as the PM)
is the presentation of the paid invoice for the purchase of the device for which the guarantee service is being invo-
ked, whereby the identity of the device in terms of type and serial number must be taken from the invoice and must
be produced by the claimant. This is subject exclusively to the PM‘s general terms and conditions of business and
sales and delivery conditions.
2. To the extent required by law and/or the installation and operating instructions, the assembly, installation, connec-
tion and commissioning of the device in question must have been carried out by a licensed electrician and/or in-
staller with due regard to the necessary instructions for this. The storage tank (without external covering or plastic
external covering) must be protected from direct sunlight in order to prevent discolouring of the polyurethane foam
and any possible warping of plastic components.
3. The room in which the equipment is operated must be free of frost. The assembly of the equipment must be carried
out at a location which can be reasonably expected i.e. the equipment must be easily accessible and replaceable
in the event of necessary maintenance, repair and possible replacement. The costs for any necessary changes to
the structural conditions (e.g. doors and corridors too narrow) are not covered by the guarantee and warranty oe-
red and shall therefore be refused by the PM. When setting up, installing and operating the water heater in unusual
places (e.g. lofts, living quarters with water sensitive ooring, store rooms etc.) potential water leakage must be
taken into consideration and therefore a device for capturing and draining o any leaked water must be provided
in order to prevent secondary damage in the sense of the product liability provisions.
4. The warranty shall not apply in the following cases:
Improper transportation, normal wear and tear, deliberate damage or damage through negligence, any applicati-
on of force whatsoever, mechanical damage or damage due to frost or resulting from exceeding the operational
pressure stated on the rating plate even once, the use of connection ttings that do not comply with the applicable
standards or non-functioning storage tank connection ttings, as well as unsuitable and non-functioning operating
ttings, glass or plastic part breakage, any colour dierences, damage through improper use, particularly by failing
to observe the operating and assembly instructions (operating and installation instructions), damage caused by
external inuences, connection to the wrong voltage, corrosion damage due to aggressive waters not suitable as
drinking water in accordance with national guidelines (such as the Austrian Drinking Water Ordinance TWV – BGBI.
II no. 304/2001), Deviations of up to 10 K in the stated hot water temperature compared to the actual drinking
water temperature from the storage tank (hysteresis of the regulator and possible cooling as a result of pipelines),
continued use in spite of a defect, unauthorised modications to the device, installation of additional components
which have not been tested with the device, improperly performed repairs, insucient conductance of the water
(at least 150 S/cm), operational wear and tear of the magnesium anode (consumable part), natural limestone for-
mation, water deciency, re, ood, ooding, lightning strike, excess voltage, power failure and other force majeu-
re, use of non-original and third party components, e.g. heating rod, protective anode, thermostat, thermometer,
nned tube heat exchanger etc. components installed in a way that is non-insulated with regard to the storage
tank, inux of foreign material and electrochemical installations (e.g. mixing installations), non-observance of the
planning documents, late and non-documented renewal of the installed protective anode, faulty installation and
connection of the external current anode (e.g., no permanent power supply), lack or improper cleaning and opera-
tion as well as deviations from the standard, which only slightly impair the value or the functionality of the device.
Furthermore, the original installation at the place of assembly may not be altered or retrotted before an inspec-
tion by the manufacturer or a commissioned expert. Any changes to the original installation on site will result in
the immediate exclusion of all possible claims from the warranty or guarantee as well as product liability claims.
In addition, as a matter of basic principle, all regulations set out in ÖNORM B 2531, DIN 1988 (EN 806), DIN 1717,
VDI 2035 or the corresponding national regulations and legislation must be complied with.
5. In case of a justiable claim, this must be reported to the nearest PM customer services centre. They shall reserve
the right to decide whether a faulty component should be replaced or repaired and/or whether a faulty device will
be exchanged for a fault-free device of the same value. In addition the PM expressly reserves the right to demand
that the customer return the device to which the claim applies. The date of a repair or an exchange will be dened
by the producer within 5 days!
6. Repairs under the guarantee may only be carried out by people licensed to do so by the PM. Exchanged parts shall become
the property of PM. Should any repairs to the water heater be required following necessary service works these shall be
invoiced to the customer as repair and pro-rata materials costs.
… 35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Austria Email EKF series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Austria Email EKF series in the language / languages: English, German as an attachment in your email.

The manual is 0.7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info