705688
14
Zoom out
Zoom in
Previous page
1/22
Next page
14
Notes on the power supply
Connect the +12V power supply lead only after all the other leads have been connected.
Be sure to connect the ground lead of the unit securely to a metal point of the car. A loose connection
may cause a malfunction of the amplier.
Be sure to connect the remote control lead of the car audio to the remote terminal,
When using a car audio without a remote output on the amplier, connect the remote input terminal
(REMOTE)to the accessory Power supply.
Use the power supply lead with a fuse attached <7. 5A 2).
Place the fuse in the power supply lead as close as possible to the car battery.
Make sure that the leads to be connected to the +12Vand GND terminals of this unit are larger
than 10-Gauge (AWG-10) or have a sectional area of more than 5 (mm)
Precautions
This unit is designed for negative ground 12V DCoperation only.
Use speakers with suitable impedance.--2 to 16ohm (stereo).
Do not connect any active speakers (with built~in amplier)to the speaker terminals of the nuit.
Avoid installing the unit where:
- it would be subject to high temperatures such as from direct sunlight or hot airfrom the heater.
- it would be exposed to rain or moisture.
- it would be subject to dust or dirt. If your car is parked in direct sunlight and there is a considerable
rise in temperature inside the car, allow the unit to cool down before use.
When installing the unit horizontally, be sure not to cover the ns with the floor carpet etc.
If this unit is placed too close to the car radio, interference may occur. In this case, relocate the
amplier away from the car radio.
If no power is being supplied to the master unit, check the connections.
This power amplier employs a protection circuit to protect the transistors and speakers if the
amplier malfunctions.
Do not attempt to test the protection circuit by covering the heat dink or connecting improperloads.
Do not use the unit on a weak battery as its optimum performance depends on s good power supply.
For safety reasons, keep you caraudio volume moderate so that you can still hearsounds outside your car.
Protection circuit
This amplier is provided with a protection circuit that operates in the following cases:
- when the unit is overheated
- when a DC current is generated
- when the speaker terminals are short circuited.
The PROTECTOR indicator lights up in red and the unit will shut down.
If this happens, turn o the connected equipment, take out the cassette tape or disc, and determine
the cause of the malfunction, If the amplier has overheated, wait until the unit cools down beforeuse.
Installation
Before installation
Mount the unit either inside the trunk or under a seat
Choose the mounting location carefully so the unit will not
interfere with the normal movements of the driver and it will
not be exposed to direct sunlight or hot air from the heater.
Do not install the unit under the floor carpet, where the heat
dissipation from the unit will be considerably impaired.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Auna Silverhammer4 - 10006686 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Auna Silverhammer4 - 10006686 in the language / languages: English, German as an attachment in your email.

The manual is 2,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info