Manual Auna MD-170BT 10007166 (page 11 of 17) (English, German)

653094

Zoom out

Zoom in

1/17

• Try not to connect wires over or near any hot surface, especially those wires connected to the

engine accessories;

• It is forbidden to dismantle the power cable of the said product and meanwhile, use such cable to

power other products of different model. Over-current is likely to lead to  re disaster;

• Replace old fuse with a new one with the same speci cations;

• Install the said product with supplied screws;

• Bundle wires and cables together or via tapes when installation is completed;

• Do not use the said product in a rainy, damp or dusty environment;

• Do not install the said product in a location that vibrates or is hard to secure;

• Try not to block any ventilation or radiation openings.

General Instructions

• Do not modify or dismantle the said product on your own so as not to trigger any accidental

events,  re hazard and electric shock;

• For the sake of driving safety, try to keep the volume down;

• While washing the automobile, necessary caution must be exercise as electric short-circuit or other

hazards could be set off if any water is splashed over the said product (including the speakers);

• Wiring and installation are required to be performed by professionals. As skills and experience are

essential while installing the said product and connecting relevant wires and cables, it is strongly

suggested to contact relevant dealers for installation.

• If detected any abnormality, please stop using the said product immediately. Otherwise, such

product could be damaged more seriously. For details, contact the corresponding professional

technicians.

• As the said product consists of numerous precision components, any attempt to dismantle or ad-

just any component is strictly restricted. When maintenance is needed, please send such product

to the locations as appointed by the company for maintenance.

Precaution

• The said product is powered by means of a 12V AC accumulator which is grounded via the negative

electrode;

• Please connect as per the wiring diagram so as to avoid any device damage;

• Before connection, strip off the insulation layer long as 5mm on both ends of the wires;

• Do not power on until connection is  nished;

• Insulate any exposed live part in order to prevent short-circuit with the automobile chassis.

• Bundle all the wires and cables so as to prevent any terminals making contact with any metal

object;

ATTENTION:

As for any automobile equipped with computer or satellite navigation system, the

information stored could be totally erased when the battery terminal is pulled off.

Attention when connecting speakers

• Do not use any grounded speakers;

• The power of the speaker in use must exceed 40W as it is required to accept maximum output

power of the ampli er;

• The speaker has resistance ranging between 4~8ohm. Any resistance not covered by such range

could affect output power and even damage the speaker or the said product;

• The speaker wires should be approximately 30mm away from the antenna and antenna extension

cable;

• Please follow the diagrams to connect correctly so as to safeguard either the speaker or the said

product.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Auna MD-170BT 10007166 in the language / languages: English, German as an attachment in your email.

The manual is 3,2 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Auna MD-170BT 10007166 Manual

Product: