4
TRM4 and TRM6
INSTRUCTIONS
Put the Terminal or the Raccord onto a flat surface. (As far as Terminals are concerned, the side with grilles must
be facing upwards). Remove the front plate fixed through four screws by using multispanner supplied with the
devices (pict. 1 and 2). Place the fans groups onto the flat surface and push them in order to insert them inside the
extension body you are using, so that the fans group support guides snap into the slots (pict. 3).
Warning!: Do not push hard onto the fans wheel while mounting the fans group.
Fans group insertion inside Terminals and Raccords
1
2
3
After inserting the fans, mount
Terminals front plate back again
(pict. 4). If parts were assembled in
the right way, the fans wheels will
be in the same side as the grilles of
the plate itself.
TRM4 and TRM6
TRM4 and TRM6
TRM4 and TRM6
TRM6
General procedure for insertion inside Raccords
Remark for TRM4:
Do not turn the Terminal body while
mounting it. Its correct direction is
when the screw in the wooden strip
is closer to the flat surface the
terminal lies onto (pict. 2).
Remark for TRM6:
Insert the special spacers inside TRM6 in
order to avoid air flux dispersion by making
them slide onto the terminal proper slots
until they touch the fans.
Remark for Raccords:
Insert the fans and a sufficient
number of spacers into the
Raccord by making them slide
onto the proper slots, in order
to avoid air flux dispersion. The
last spacer must always be a
Terminal Spacer.
General procedure for insertion inside Terminals
- 10 -
VRx4.300 connections
Inputs and outputs:
bridge connection
Power supply, remote and accessories Inputs and outputs:
stereo connection
Inputs and outputs:
Front + Sub
- 59 -
Please see “Technical
Features” and “External
fuse size and location” in
order to choose the
proper external fuse.
