Subject to technical changes
INSTALLATION
ISO DIN Installation
This unit is designed to fit into a 2.0 DIN dashboard opening, found in many imported cars. The unit has threaded holes in the chassis side panels
which may be used with the original factory mounting brackets of some Toyota, Nissan, Mitsubishi, Isuzu, Hyundai and Honda vehicles to mount
the radio to the dashboard. Please consult with your local car stereo specialty shop for assistance on this type of installation.
1. Remove the existing factory radio from the dashboard or center console mounting. Save all hardware and brackets
as they will be used to mount the new radio.
2. Remove the four screws at the front of the radio that attach the mounting sleeve to the radio chassis (two at the top and two at the bottom).
Remove the Half Sleeve.
3. Remove the factory mounting brackets and hardware from the existing radio and attach them to the new radio.
CAUTION: Do not exceed M5 X 6MM screw size. Longer screws may touch and damage components inside the chassis.
4. Place the radio in front of the dashboard opening so the wiring can be brought through the dash. Follow the
wiring diagram carefully and make certain all connections are secure and insulated with wire nuts or electrical tape. After completing the wiring
connections, plug the ISO connectors into the mating sockets on the rear of the chassis. Turn the unit on to confirm operation
(vehicle ignition switch must be “on”). If the unit does not operate, re-check all wiring until the problem is corrected.
5. Mount the new radio assembly to the dashboard o center console using the reverse procedure in step 1.
CAUTION: For proper operation of the CD player, the chassis must be mounted within 30° of horizontal. Make sure the unit is mounted within this
limitation.
NOTE: It is the end-users responsibility to install and operate this unit in a manner in accordance with local, state and federal laws. The PARKING
BRAKE wire MUST BE CONNECTED as directed in the manual.
5
