583736
11
Zoom out
Zoom in
Previous page
1/20
Next page
11
Entry Illumination Detail
Green w/Black Trace Wire: 300mA Latched Channel 3 Output
The Green w/Black Trace wire supplies a 300mA switched output whenever channel three of the receiver is ac-
cessed. Pressing the pre-programmed transmitter button(s) will access channel three and will remain active, for up to 8
seconds, as long as the transmitter button(s) is held. This is a low current output and must be connected to a relay to
supply power to the device you intend to control. Connect Green w/Black Trace wire to terminal #86 of a VF45F11
P&B relay or equivalent. Connect terminal #85 of the relay to a fused + 12 volt source. Connect the common,
normally open, and normally closed contacts of the relay to perform the selected function of the channel 3 output.
CAUTION! Connecting the dark green w/black trace wire to any high current switched output (300mA max.)
will damage the control module.
Dark Blue/Black and Green/White - 2 Pin Input/Output Harness:
Dark Blue/Black Trace Wire: External Trigger Input
The Dark Blue/Black trace wire allows the remote start unit to be activated from an external source. The intent of this wire
is to allow the unit to be controlled from a "POSSE/CAR-LINK" paging system or similar device. When this wire receives
a ground pulse, the unit will start the vehicle. Connect this wire to a ground pulsed output from the controlling circuit.
Green w/White trace Wire: Entry Illumination Ground Output
This wire provides a 30 second ground output (300mA Max.) whenever the remote is used to unlock the doors . This
wire should be connected to an external relay, and wired to the vehicles interior entry lighting whenever the optional
Interior Illumination circuit is desired. See below for relay wiring details.
1 Flash
1 Second Door Locks
10 Minute Run Time
Park Lights Steady On
(No Function)
(No Function)
Ign. 2 Off During Crank
Diagnostics Off
(No Function)
Gasoline Engine
Starter Pole 5X
2 Flashes
3.5 Second Door Locks
15 Minute Run Time
Park Lights Flash
Tach Operation
(No Function)
Ign. 2 On During Crank
Diagnostics On
(No Function)
Diesel Engine
Starter Pole 3X
Default
1 Second
10 Minute
Steady
Tach
------------
Off During Crank
Off
-------------
Gasoline
Pole 5X
Feature Selection
First
Second
Third
Fourth
Fifth
Sixth
Seventh
Eighth
Ninth
Tenth
3 Flashes
1 Second L/Dbl U/L
1. RF Programmable Features:
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Audiovox AA-RS30CS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Audiovox AA-RS30CS in the language / languages: English as an attachment in your email.

The manual is 0,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info