618699
4
Zoom out
Zoom in
Previous page
1/40
Next page
VQT2R77
4
Control guide
ENGLISH
TEST terminal
ID switch
4
As this system uses a frequency band of 2.4 GHz, the radio waves
may be interrupted by an obstacle. Depending on the surrounding
environment (i.e. radio wave interruption from outside, etc.) or the
building structure where this system is used (i.e. wall that easily
reflects radio waves, etc.), sounds may be cut or noise may occur.
Install this system properly paying attention to the following descriptions.
Equipment certification
As this system received Technical Conditions compliance certi cation
based on the Radio Law, the wireless station license is not required.
However, if you do the following actions to this system, you may be
punished by law.
Disassemble or refurbish
Restrictions for use
Domestic use only.
Use this system in the same room.
Do not place an obstacle between the main unit (SC-ZT2) and
speakers. Do not put things on the main unit.
Radio
waves from this system reach maximum range of 15 m in the
same room. If there is an obstacle between the main unit (SC-ZT2) and
speakers or the main unit (SC-ZT2) is placed at the height of 50 cm or
below from the floor, the
radio
waves reach smaller range.
Keep this system away from equipment that generates radio
wave interference.
If the following equipment is located near the system, install this
system away from such equipment.
Bluetooth, OA devices, telephone, etc.: approx. 3 m or more
Microwave oven, wireless LAN compatible devices: approx. 3 m
or more
This system is designed to automatically avoid radio wave interference
with such household equipment. If radio wave interference occurs, the
Wireless Link display ( page 16 of SC-ZT2 Operating Instructions)
may blink, the sounds from speakers may be interrupted or noise may
occur.
These phenomena occur when this system selects a proper
frequency. These are not malfunctions.
Keep this system away from metal objects that tend to reflect
radio waves.
If there are metal objects or furniture in the room where this system is
installed,
radio
waves tend to be reflected. Depending on the listening-
viewing position, sounds may be interrupted or noise may occur. These
symptoms may be remedied by slightly moving this system’s position.
Note that radio waves tend to be reflected also when this system is
installed in rooms with a lot of activity.
There is no positional distinction for each speaker before setting.
Make sure to place the speakers on a flat, stable surface so
there is no danger of them falling over.
When carrying speakers, hold the pole and base parts. (below)
The speakers of this system are not magnetically shielded. Do
not install this system near a CRT-based television.
Note
Make sure the base parts are not covered by cloth such as a curtain.
Before attaching the leg cushion (included) on the base parts to
prevent tilt or rattle on the floor, make sure there are no people in
the surrounding area.
Set the distance from each speaker to the listening-viewing position.
(page 24 of SC-ZT2 Operating Instructions)
Setup example
Front speaker
(right)
Front speaker
(left)
Connected equipment
Main unit
Surround
speaker
(left)
Surround
speaker (right)
Approx.120°
Supplied accessories/AC mains lead connection/Installation/Control guide
Place the surround speakers slightly at the back right and left of the listening-viewing position.
Aim the front face (with Panasonic logo) of each speaker at the
listening-viewing position for setting.
Installation
Wireless functions
Please check and identify the supplied accessories.
Use numbers indicated in parentheses when asking for replacement parts.
(Product numbers correct as of February 2010. These may be subject to change.)
Supplied accessories differ depending on the symbols
(E, GN, GS) indicated on the packaging box.
Use correct accessories according to the region for use.
Supplied accessories
AC IN
TEST
ID
2
1
Speaker (with built-in amplifier)
TEST terminal: This is used to check the product operation status.
Only used in factory. Do not insert a foreign object.
ID switch: This is used to check the product operation status and not
used regularly.
WIRELESS LINK
Pole (mid-high part)
Base
(woofer
part)
Side view
AC inlet ( left)
1
[WIRELESS LINK] indicator ( right
page)
When the unit is connected to the AC mains
supply, this indicator lights red in standby mode
and lights green when the unit is turned on.
2
Unit on/off button (k I l ^) ( right page)
Use this button to turn the unit on and off.
l (off): The unit is in standby mode.
k (on): The unit is on.
The unit is still using a small amount of power in
the standby. Standby uses less power.
Note
2 AC mains leads
For E
(For the United Kingdom and Republic of Ireland)
(K2CZ3YY00005)
(For continental Europe)
(K2CQ2CA00007)
For GN
(For Australia and New Zealand)
(K2CJ2DA00010)
For GS
(For Saudi Arabia, Kuwait,
Malaysia and Hong Kong)
(K2CZ3YY00005)
(220 to 240 V)
(For Saudi Arabia)
(K2CA2CA00031)
(110 to 127 V)
(For Thailand)
(K2CP2CA00001)
(For others)
(K2CQ2CA00007)
Leg cushion (1 sheet: 8 pieces) (RFA3045-2)
Keep the leg cushion out of reach of children to prevent swallowing.
Refer to page 3 for Sales and Support Information (for the United Kingdom and
Republic of lreland).
The supplied AC mains leads are for use with this system only. Do not use them
with other equipment. Also, do not use AC mains lead for other equipment with
this system.
Note
AC IN
To save power when the system is not to be used for a long time,
unplug it from the household mains socket.
Make sure to turn this system off before unplugging the AC mains lead.
For power consumption of speakers in standby, see page 5.
Power supply differ depending on the symbols (E, GN, GS) indicated on the packaging box.
AC mains lead connection
Household mains socket
For E, GN
(AC 220 to 240 V, 50 Hz)
For GS
(AC 110 to 240 V, 50/60 Hz)
AC mains lead
(supplied)
Side view
FOR THE UNITED KINGDOM, REPUBLIC OF IRELAND, SAUDI
ARABIA, KUWAIT, MALAYSIA AND HONG KONG ONLY
READ THE CAUTION FOR THE AC MAINS LEAD ON PAGE 3
BEFORE CONNECTION.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Audiosonic SCZT2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Audiosonic SCZT2 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 4,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Audiosonic SCZT2

Audiosonic SCZT2 User Manual - English - 32 pages

Audiosonic SCZT2 User Manual - German - 92 pages

Audiosonic SCZT2 Installation Guide - German - 8 pages

Audiosonic SCZT2 User Manual - Dutch - 100 pages

Audiosonic SCZT2 Installation Guide - Dutch - 8 pages

Audiosonic SCZT2 User Manual - Danish - 100 pages

Audiosonic SCZT2 Installation Guide - Danish - 8 pages

Audiosonic SCZT2 User Manual - French - 92 pages

Audiosonic SCZT2 Installation Guide - French - 8 pages

Audiosonic SCZT2 User Manual - Italian - 92 pages

Audiosonic SCZT2 Installation Guide - Italian - 8 pages

Audiosonic SCZT2 User Manual - Polish - 100 pages

Audiosonic SCZT2 Installation Guide - Polish - 8 pages

Audiosonic SCZT2 User Manual - Swedish - 100 pages

Audiosonic SCZT2 Installation Guide - Swedish - 8 pages

Audiosonic SCZT2 User Manual - Spanish - 100 pages

Audiosonic SCZT2 Installation Guide - Spanish - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info