531031
5
Zoom out
Zoom in
Previous page
1/73
Next page
GB-4
LOCATION OF CONTROLS
1) CD DOOR
2) FM STEREO LED INDICATOR
3) CD PLAY/PAUSE
BUTTON
4) CD SKIP DOWN
BUTTON
5) CD SKIP UP
BUTTON
6) CD STOP
/ BAND SELECT BUTTON
7) LCD DISPLAY
8) VOLUME UP BUTTON
9) VOLUME DOWN BUTTON
10) FUNCTION SELECTOR BUTTON
11) MP3 FOLDER UP BUTTON
12) USB SOCKET
13) 3.5MM HEADPHONE JACK
14) FM MONO / FM STEREO SELECTOR
15) CD DOOR OPEN BUTTON
16) REMOTE SENSOR
17) POWER STANDBY LED INDICATOR
18) POWER ON/STANDBY BUTTON
19) TUNING KNOB
20) CLOCK ADJUST / PRE-SET EQ BUTTON
21) SD/MMC CARD SLOT
22) DUST COVER
23) FM WIRE ANTENNA
24) SPEAKER WIRE CONNECTOR (L/R)
25) RCA AUX-IN JACK
26) AC POWER CORD
CAUTION:
USAGE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED
HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE PERSONNEL.
IMPORTANT:
SINCE MOVEMENT OF THE CD MECHANISM AND THE SENSITIVE CIRCUITY MAY CAUSE INTERFERENCE TO THE
RADIO TUNER NEARBY, SWITCH THIS UNIT OFF WHILE OPERATING OTHER
RADIO DEVICES.
PRECAUTIONS FOR USE
INSTALLATION
UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAIN VOLTAGE AND BEFORE ALL OTHER
CONNECTIONS HAVE BEEN MADE.
DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL CENTIMETERS AROUND THE
UNIT FOR VENTILATION.
CONNECTION
1. CONNECT THE POWER CORD (26) TO AC OUTLET
2. WHEN YOU FIRST PLUG THE UNIT INTO THE MAINS, THE UNIT WILL GO INTO STANDBY MODE AND THE LCD
INDICATOR (7) WILL LIGHT UP, THE DISPLAY WILL SHOW “12 :00 ” AND START FLASHING.
3. CONNECT THE SPEAKER WIRE TO THE SPEAKER TERMINAL (25) LOCATED ON THE REAR SIDE OF UNIT.
4. TURN ON THE POWER (18), IF THE LCD DISPLAY IS ON WITH BACKLIGHTING, IT MEANS THE POWER SUPPLY IS
NORMAL. NOW YOUR SYSTEM IS READY TO PLAY THE MUSIC.
SETTING THE CLOCK
1. SET UNIT IN STANDBY MODE.
2. PRESS & HOLD THE “CLK-ADJ/PRESET EQ” BUTTON (20), THE DISPLAY WILL SHOW 12h OR 24h AND THEN
PRESS
OR BUTTON (4,5) TO SELECT THE APPROPIATE AREA HOUR (12H/24H)
3. PRESS “ CLK-ADJ/PRESET EQ ” BUTTON (20) AGAIN, THE FIRST SECOND DIGIT OF IS FLASHING. PRESS
OR
BUTTON (4,5) TO SET THE CORRECT HOUR. PRESS ” CLK-ADJ/PRESET EQ ” BUTTON (20)TO STORE THE
CORRECT HOUR.
4. THE THIRD FOURTH DIGIT IS FLASHING, PRESS THE
OR BUTTON (4,5) TO SET THE CORRECT MINUTES.
THEN PRESS “ CLK-ADJ/PRESET EQ ” (20) TO STORE THE CORRECT MINUTE.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Audiosonic HF-1255 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Audiosonic HF-1255 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 1,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info