68270
6
Zoom out
Zoom in
Previous page
1/76
Next page
6
POWER SUPPLY
If you would like, the electrical power supply can be used to save the batteries. Make
sure that the unit is unplugged from the wall outlet before inserting the batteries.
USING THE DC POWER SUPPLY
Batteries (not included)
Open the battery compartment and insert 8 R14 batteries with respect to the "+" and
"-" polarity indications in the compartment.
Important:
When replacing the batteries, make sure you dispose of the old batteries in
accordance with applicable regulations. They should be disposed of in a location
specifically designated for that purpose so they can be recycled safely and without
posing any risk for the environment. Do not burn or bury them. Incorrect use
of the batteries may result in electrolyte leakage having a corrosive effect in the
compartment.
Do not mix dierent types of batteries: do not use alkaline batteries with saline batteries,
for example. only use batteries of the type recommended by the manufacturer.
Do not mix old and new batteries when inserting new ones.
If the unit is not to be used for an extended period of time, remove the batteries
from the unit.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
Warning: excessive sound pressure from earphones and headphones can cause
hearing loss.
USING THE AC POWER SUPPLY
1. Make sure that the voltage indicated on the manufacturer's nameplate in the
battery compartment corresponds to the voltage supplied by your electrical
installation. If this is not the case, consult your dealer or service center.
2. Connect the electrical power cable the unit then plug it into the wall outlet. The
wall outlet must be located near the product and be easily accessible.
3. To turn power to the apparatus off, unplug the power supply cable from the wall
outlet.
4. To protect the unit during violent thunderstorms, unplug the power supply cable
from the wall outlet.
GENERAL OPERATION
GENERAL OPERATION
1. Select the source by setting the FUNCTION SELECTOR to CD/MP3/USB, OFF or
RADIO.
2. Set the desired volume level using the VOLUME KNOB.
3. To turn off the unit, set the FUNCTION SELECTOR to OFF.
RADIO
To listen to the FM radio, extend the telescopic antenna and orient it for optimum
reception. Reduce the length of the antenna if the signal is too strong (if you are
very near the transmitter, for example).
As the unit is equipped with a built-in antenna, the telescopic antenna does not
have to be used to listen to MW stations. Move the entire unit to orient the built-in
antenna.
RADIO RECEPTION
1. Set the FUNCTION SELECTOR to RADIO.
2. Position the FREQUENCY BAND SELECTOR on the desired band: MW, FM or FM ST.
3. Turn the TUNING CONTROL to search for the desired station.
NOTE: The FM stereo indicator comes on if the FREQUENCY BAND SELECTOR is set
on FM stereo and you have tuned the radio to an FM stereo station.
4. Adjust VOLUME CONTROL for the desired volume level.
5. When you have finished listening to the radio, position the FUNCTION SELECTOR
to OFF to turn the unit off.
Instruction Manual
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Audiosonic CD 570 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Audiosonic CD 570 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 1,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info