501021
23
Zoom out
Zoom in
Previous page
1/36
Next page
- Commissioning -
3.5 Connecting the telephone
Connect the telephone cable supplied to the telephone socket and the telephone
jack marked LINE on the underside of the telephone. Then feed the cable out of
the telephone housing either upwards or downwards through the cable guide. Clip
the cable firmly in the cable channel.
The AUDIOLINE 38 telephone works using the tone dialling system.
3.6 Private exchanges - T-NET set-up
You can use the “R” signal button on your telephone on private exchanges and
when using DEUTSCHE TELEKOM’s T-Net functions. If you use neither a private
exchange or the T-NET-functions of the DEUTSCHE TELEKOM, no adjustments
must be made here.
Private exchanges
If you have connected your telephone to a private exchange, you can use all the
facilities such as call transfer, automatic recall, etc. The “R” signal button gives
you access to these facilities. The FLASH time “100ms” (factoty setting) will be
required on a private exchange. To make this setting, move the slide switch on
the underside to the “100ms” position. You can find out from the dealer from
whom the equipment was purchased whether your telephone will work on your
private exchange without any problems and which other facilities you will have
access to.
T-NET functions
Your telephone supports the most important DEUTSCHE TELEKOM added value
services (e.g. brokering, call waiting, three-way conferencing, etc.). Please
contact DEUTSCHE TELEKOM to gain access to these functions (some of which are
subject to charge). When using T-NET functions, move the slide switch on the
underside to the “300ms” position.
Note: If the desk support has already been fitted, the FLASH slide switch can be
found underneath this support.
3.7 Fitting the desk support
If you intend to use your telephone on a desk, then the desk support supplied
must be fitted. To do this, turn the telephone over. Now insert the two upper
hooks into the openings provided and push the desk support firmly home.
If you ever need to remove the support, press gently on the middle clips on the
upper edge and then pull the desk support off.
In the receiver rest there is a small hanging device, which is used when the
telephone is wall mounted. This hanging device is not required when the
telephone is used on a desk, as it impedes the lifting of the receiver. Using a small
screwdriver, turn this hanging device until the screw is completely flush and its
upper end does not protrude at all.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Audioline TEL 38 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Audioline TEL 38 in the language / languages: English, German as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info