501414
44
Zoom out
Zoom in
Previous page
1/76
Next page
- Setting up -
44
3 Setting up
3.1 Safety information
NOTE: Before setting up, it is essential that you read the Safety Information at the beginning of
this operating manual.
3.2 Check contents of pack
The following items are supplied:
one base station with power supply
(big) one charger with power supply (small)
two handsets with belt clip four standard batteries
one telephone connecting cable one instruction manual
3.3 Connecting the base station
Position the telephone near to your telephone connection socket and to a mains socket.
1. Insert the plug of the power supply into the socket on the underside of the base station and
plug the power supply into a properly installed 230 V mains socket. The plug-in power
supply for the base station must always be connected. For safety reasons, use only the
plug-in mains power supply provided.
2. Connect the telephone cable supplied to the telephone socket and the telephone jack on
the underside of the base station. Use only the new telephone cable provided.
3. Run the two cables through the two cable channels to the rear of the base station.
3.4 Connecting the charger
Set up the charger within reach of a electricity supply socket. Insert the red connector on the
lead from the transformer plug in the socket on the underside of the charger and insert the
transformer plug in a 230V supply socket installed in accordance with regulations. For safety
reasons, use only the transformer plug supplied. Press the cable into the cable channel leading
to the rear of the charger.
3.5 Fitting standard batteries
To fit the standard rechargeable batteries supplied into the handset, press
on the upper edge of the battery compartment and slide it downwards.
Now insert the batteries taking care to ensure that the polarity is correct.
Close the battery compartment cover.
Important note: Place the handset in the base station with the display to the front for at least
16 hours. The telephone may malfunction if the batteries are not properly charged. The charging
light on the base station will come on.
3.6 Charging the standard batteries
The rechargeable batteries for your telephone have a stand-by time of max. 100 hours at room
temperature and a maximum talk time of up to 10 hours. The current battery capacity is shown
in the display.
Full
Half
Low
If the battery capacity is too low, the symbol will flash in the display and you will hear warning
tones every 60 seconds.
To charge the batteries, place the handset in the base station with the display to the front.
+
AAA
+
AAA
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Audioline STUDIO 80-B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Audioline STUDIO 80-B in the language / languages: English, German as an attachment in your email.

The manual is 0,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info