501301
29
Zoom out
Zoom in
Previous page
1/52
Next page
- General Instructions -
29
Private branch exchanges
The telephone can also be connected to a private branch exchange. The dealer where
you purchased the private branch exchange will tell you if your telephone will work
properly on your PBX. Due to the great variety of private branch exchanges, we cannot
guarantee that the phone will work properly on all PBXs.
Location of the base station
The base station must be located within reach of a 230Volt supply socket. To avoid
interference problems, do not place the base station in the immediate proximity of other
electronic equipment such as a microwave oven or hi-fi system. The location of the base
station can significantly influence the proper function of the telephone.
Place the base station on a level, non-slip surface. The feet of the base station will not
normally mark the surface on which it stands. However, the wide range of surface
finishes in use renders it impossible to exclude marking of any surface.
Do not use the handset in areas where there is a danger of explosion.
Avoid excessive exposure to smoke, dust, vibration, chemicals, humidity, high
temperature or direct sunlight.
Note for medical products
The telephone works with very low transmitted power. Present knowledge and research
indicate that, at this low power level, there is no possible danger to health. It has,
however, been shown that portable telephones, when switched on, can affect medical
equipment. Maintain a distance of at least one metre from medical equipment.
Disposal
If the batteries or the complete system have reached the end of their useful life, please
dispose of them in an environmentally friendly manner and as required by law.
Temperature and ambient conditions
The telephone is designed for indoor use and an operating temperature range of 10 °C to
30 °C.
The base station must not be installed in humid areas such as bath or wash rooms. Avoid
proximity to sources of heat such as radiators and do not expose the unit to direct
sunlight.
Cleaning and care
The outer surfaces of the unit can be cleaned with a soft, dry, lint-free cloth. Never use
cleaning agents or aggressive solvents. Apart from occasionally cleaning the outer
surfaces, no further care is required. The rubber feet of the base station are not resistant
to all cleaning agents. The manufacturer cannot, therefore, be held responsible for
damage to furniture etc.
CE marking
The telephone is compliant with the essential requirements of the R&TTE Directive. This
is certified by the CE marking.
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Audioline DECT 5501 plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Audioline DECT 5501 plus in the language / languages: English, German as an attachment in your email.

The manual is 0,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info