619827
17
Zoom out
Zoom in
Previous page
1/20
Next page
15
GB
Symptom - Possible Cause - Solution
Lights on Control Unit don’t illuminate when turned ON
Batteries are not inserted correctly or may be flat.
Check batteries are inserted in the Control Unit observing the correct polarity.
Control Unit requires 4 X AA 1.5V Alkaline batteries (not supplied).
Low battery voltage warning (red light) on the Control Unit
• Batteries low.
Replace all 4 batteries.
False alarm up to 1/2 minute from activating
Sensor pad is out of order.
Cable is connected to monitors blocked socket.
Connect one sensor pad lay the baby on the bed for 1 minute. If the alarm does not acti-
vate, the sensor pad is in order. If the alarm activates, disconnect and place the sensor
pad aside.
Connect the other sensor pad and repeat steps above.
Do not connect any cables to the blocked socket (only to “SENSOR” socket).
False alarm after 1/2 minute from activating
The mattress is not touching the sensor pads.
The mattress is raised (there is an object near the sensor pads).
Make sure that the mattress and the sensor pads are touching.
Make sure that there are no objects next to the sensor pads.
Placing two sensors next to each other (or using one sensor) when the baby is of crawling age
or using two sensor pads far apart from each other when baby is young and is not crawling yet.
Connect according to instructions.
It is important to use only one sensor pad when the baby is young and is not crawling yet.
It is important to make sure that two sensor pads are used when the baby is moving
around.
Make sure the sensors are placed underneath baby’s location in bed/crib.
The mattress does not enable transfer of baby movements. (a rigid mattress, a mattress with
springs or a mattress with air pockets).
Place extra plywood under the sensor pad so that the sensor pad and the mattress will be
tightly pressed together.
Delayed alarms while taking the baby out of the bed
Performance test is not correct.
Do not conduct performance test by picking up the baby out of bed and waiting for the
alarm to sound. Kindly conduct performance test according to guidance in page 14.
The alarm does not go off within 20 seconds when performing the correct performance test
Environmental influences detected by the sensor pads, such as wind, fan, air conditioner, mobi-
le, vibrations.
Appendix
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Audioline Babysense 5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Audioline Babysense 5 in the language / languages: English, German as an attachment in your email.

The manual is 0,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info