Setting the zoom
You can zoom in on the image.
Press and hold this button for approx. 2 seconds.
The zoom will be activated. You can move the selection, as long as four arrows are
shown in the display (approx. 5 seconds), by pressing the button to the left,
to the right, upwards or downwards.
To deactivate the zoom function press and hold this button again for approx. 2 seconds.
Selecting a lullaby
Switch on: press the button briefly.
This icon appears in the display.
Use these buttons to select one of the 5 lullabies (1-5).
Switch off: press the button briefly.
Intercom function
Press and hold the button.
This icon appears in the display.
Speak into the microphone to talk with the person near the other unit. When the talking
button is pressed, any playing of lullabies will be aborted.
Range
When the distance between the transmitter and receiver is too far, the message “Out of Range“ appe-
ars in the display and you hear a beep. Move the receiver nearer to the transmitter. If necessary, opti-
mum range can be achieved if both the Baby unit and Parent unit antennas are extended vertically.
Registration
In delivery state the transmitter is pre−registered at the receiver (Watch&Care V132: both transmit-
ters). If necessary or if a another camera is added to the system, registration can also be completed
manually:
1 Switch the transmitter off (switch set to OFF). Remove the batteries of the receiver for a few
seconds if necessary.
2 Switch the receiver on.
3 Press the menu key repeatedly until [C1] appears in the display.
4 Use the buttons to select the desired camera [C1] ... [C4].
5 Press the button briefly. The Link LED flickers for approx. 10 seconds. During this time,
you must perform steps 6 and 7.
6 Switch the transmitter on (switch set to ON).
