810506
70
Zoom out
Zoom in
Previous page
1/120
Next page
69
EN
Fuel storing
It is necessary to pay attention to several instructions by storing the fuel. Wood should be stored
in dry and ventilated place to prevent its moisture rise. Wood has to be stored far enough from
boiler to prevent its ignition. It is necessary to store the wood to prevent its falling down.
8 BOILER MAINTENANCE
It is necessary to maintain the boiler during its life time to make it work properly. Frequency of
maintenance depends on the utilization rate of the boiler during the operation.
Maintenance of heating system together with the boiler
At least once every 14 days, check and if it is needed fill up with water in the heating system. If
the boiler is out of order during the winter, there is a risk of water freezing in the system and
therefore drain the water from the system or fill the antifreeze. Otherwise, drain the water only in
the most necessary case and preferably for the shortest possible time. After the heating period,
clean the boiler properly, replace the damaged parts. Remove the fan twice a year and clean the
impeller and fan air chamber.
Hinges tightening and replacing sealing cord of door.
During the common operation, door cords lose their flexibility and it leads to the loss of door
tightness. We can change the door hinge position multiple times (in direction to the inside of
the boiler – to push more the door cord) to ensure maintenance and tightness increasing. When
cord lose its flexibility completely, or when the hinges cannot be further moved in direction to
the boiler, there is a need of replacement. Perform replacement by dismounting the old one
with screwdriver and clean the groove where the cord laid. Take new sealing cord and place the
beginning on the horizontal grooves. Push it in the groove at the door circumference by hand or
by tapping with hammer. Loosen hinges and find correct position of door to boiler body.
Replacing the nozzle body
Nozzle body is placed in the boiler body on the nozzle holder. In the bottom part is nozzle body
sealed with boiler sealant and in the upper part with sealing cord at its circumference. When
replacing the nozzle, remove the sealing cord from the nozzle groove by a screw driver. Take the
nozzle body out and clean the holder properly from tar and old sealant. Put the new refractory
sealant on the cleaned surface. Put the nozzle on the holder – shorter wall has to be in the rear
part of the boiler up to the end. There should be the same space on the both sides of the nozzle.
Take the new set of sealing cords for the nozzle and press it lightly into the gap just around the
nozzle
70


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATTACK SLX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATTACK SLX in the language / languages: English as an attachment in your email.

The manual is 12.12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATTACK SLX

ATTACK SLX Additional guide - English - 21 pages

ATTACK SLX User Manual - German - 112 pages

ATTACK SLX Additional guide - German - 21 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info