810506
7
Zoom out
Zoom in
Previous page
1/120
Next page
6
EN
We recommend to connect the boiler with accumulation tank with minimum volume of 70 l
to 1 kW boiler output.
Use only dry fuel with 12–20 % moisture (with higher fuel moisture is decreased boiler out-
put and increases its consumption)
Right choice of the boiler size, i.e. its heat output, is very important condition for economical
operation and correct function of the boiler. Boiler has to be chosen according to its nominal
output, which must meet the heat losses of the heated object.
WARNING: Boiler might be used only for intended purpose and only in the way de-
scribed in this manual.
CAUTION!: After the boiler disconnection from electricity mains during the operation,
burning continues in the sustain mode. Do not open the boiler door until the tempera-
ture drops below 40 °C.
The boiler warranty is not valid, if:
Is not operated with prescribed fuel
In the system is not installed the mixing device ATTACK – OVENTROP, which ensures the
backflow water temperature to the boiler at least 65 °C during the operation
Functional thermostatic valve wont be installed at the aftercooling circuit of the boiler (e.g.
WATTS STS20) and then connected to the source of the cooling water.
Boiler is not installed according to the requirements stated in this manual, e.g. correct di-
mensions of the chimney etc.
Is not sufficiently cleaned according to the instructions given in this manual
This appliance is not intended for use by persons (including children) with physical, sensual or
mental disability or insufficient experience due to which they are not able to use the device in a
safe way without being supervised or instructed about the boiler operation by the person re-
sponsible for their safety. Do not to allow children to play with this appliance.
If the power supply cable is damaged, it must be replaced with the correct type of
the cable, which is available by producer or by a service technician!
Be careful during the work with this appliance! Lambda probe works by high tem-
peratures (300 °C) and you might get burned during careless manipulation!
1.5 TECHNICAL DESCRIPTION
Boiler is constructed for wood combustion, based on the gasifying with use of exhaust fan,
which makes forced flow in the boiler and sucks the flue gas out of the boiler. Boiler body is
made as the weld from steel plates of 6 mm thickness. In the upper part of the boiler is feeding
chamber with above – standard volume, equipped with dry sheath technology, which lowers
the condensate creation and prolong lifetime of the boiler. In the bottom part of the feeding
chamber is fireproof nozzle with longitudinal hole for crossing the wood gas to the combustion
chamber. Secondary air is brought by the nozzle and after mixing with wood gas creates burn-
ing in the combustion chamber. Combustion chamber is also the ashtray, where are collected
wastes after combustion (ash). In the rear part of the boiler body is tubular exchanger equipped
with turbulators, which serves for cleaning the exchanger and increasing the boiler efficiency.
Turbulators might be controlled manually or automatically (using engine) according to the boil-
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATTACK SLX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATTACK SLX in the language / languages: English as an attachment in your email.

The manual is 12.12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATTACK SLX

ATTACK SLX Additional guide - English - 21 pages

ATTACK SLX User Manual - German - 112 pages

ATTACK SLX Additional guide - German - 21 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info