519881

Atika TopLine 2400 Manual

15
Zoom out
Zoom in
Previous page
1/80
Next page
14
Switching on
Press the green 'I' button. The equipment will switch off
automatically if there is a power cut (no-voltage
release). Repress the green button to switch it on again.
Switching off
You can switch off the saw by pressing the red lower
button of the switch
Motor guard
The motor is equipped with a guard switch and it
switches off automatically when overloaded. The motor
can be switched on again after a cooling-down period
(approximately 5 min.). Repress the green button too.
W
W
o
o
r
r
k
k
i
i
n
n
g
g
w
w
i
i
t
t
h
h
t
t
h
h
e
e
g
g
a
a
r
r
d
d
e
e
n
n
c
c
h
h
o
o
p
p
p
p
e
e
r
r
Choose a working position alongside the
equipment or behind it. Never stand near the ejecting
opening.
Never reach into the filling or ejection opening.
Keep your face and body away from the filling
opening.
Never place hands, other parts of the body or
clothing into the filler funnel, ejection channel or in
the vicinity of other moving parts.
Check that no chopped residues are in the filling
hopper before switching on the equipment.
Do not tip or tilt the machine when the motor is
running.
When filling, be careful that no pieces of metal,
stones, bottles or other objects unintended for
processing, enter the filling hopper.
Immediately switch off the equipment and allow it to
come to a stop, if foreign objects enter the filling
hopper or if the equipment starts to make unusual
noises or vibrates. Remove the mains plug and carry
out the following checks:
−
inspect for damage,
−
replace or repair damaged parts,
− check the equipment and tighten loose parts.
You must not repair the equipment yourself if
you are unauthorized to do so.
What can I chop?
Yes:
• organic household and garden waste
e. g. hedge and tree cuttings, dead flowers and
vegetable kitchen waste.
No:
• glass, metal, plastic, plastic bags, stones, cloth, roots
with soil, food left-overs, fish or meat.
Special informations on the chopping
procedure:
Branches, twigs and wood should be broken down
immediately after they have been cut
−
material of this kinds gets very hard when it is
dry, and it therefore makers sense to reduce the
maximum branch diameters, so that it is ready for
chopping.
Remove any side shoots from branches with a large
number of twigs.
How to chop garden and kitchen waste with hight
water content and a tendency to clog
−
to prevent the machine from clogging, alternate
waste with wood containing material.
Do not allow the chopped material to pile up too high
in the area of the ejection opening. This can lead to
shredded material blocking the ejection channel, and
backing up to the filler opening.
Clean out the filler opening and ejection channel
thoroughly if the machine becomes blocked. Before
doing this, switch the motor off and disconnect the
machine from the mains power supply.
Please do not exceed the maximum branch
diameter specified for your appliance (∅ see p. 16).
The blades largely pull the material into the machine
by themselves.
Strong branches may cause overloading. This
can be avoided by pulling them back from time to
time.
If the machine is overloaded, a protective motor
switch ensures that the machine turns itself off
automatically
−
turn the shredder on again after about 5 minutes
−
during those five minutes you cannot turn the
machine, see point „Operational faults“.
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Atika TopLine 2400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Atika TopLine 2400 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 3,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info