519290
27
Zoom out
Zoom in
Previous page
1/50
Next page
27
Abb. 19
11 1
17 B
17 C
M6
Ø 6,4
17 A
M6 x 16
Abb. 20
18
17
M6
M6 x 16
20
19
Abb. 21
Ø 6,4
Lösen Sie die Sterngriffe (11)
Schwenken Sie Teil 1
Verlegen Sie das Motorkabel
Fixieren sie es mit beigefügten Kabelbindern
Schwenken Sie Teil 1 zurück und ziehen Sie die Sterngriffe
11 fest
Release the star grips (11).
Swivel part 1.
Wire the motor cable.
Fasten it with the supplied cable binders.
Pivot part 1 and tighten firmly star grips 11
Desserrez les poignées en étoile (11)
Pivotez la pièce 1
Posez le câble du moteur
Fixez-le à l’aide des serre-câble ci-joints
Tournez la pièce 1 et serrer le vis de poignée-étoile no. 11
Maak de stergrepen los (11)
Zwaai deel 1
Leg de motorkabel
Fixeren met de bijgevoegde kabelbinders
Duw deel 1 terug en draal sterknop 11 vast
Lossa stjärngreppen (11)
Sväng del 1
Lägg motorkabeln
Fixera den med bifogade kabelfästen
Sväng tillbaka del 1 och drag åt stjärngrepp 11
Suelte los mandos estrellados (11).
Gire la pieza 1.
Tienda el cable del motor.
Sujételo con los sujetacables adjutos.
Retorne la pieza 1 a su posición inicial y apriete a fondo los
mandos estrellados (11).
Schrauben noch nicht fest anziehen!
Schrauben Sie die Tischbeine 17A und 17B an (siehe auch
Abb. 17 und 18), danach Teil 18 mit Tischbein 17C
Do not tighten the screws firmly
Fasten the table legs 17A and 17B with the screws (see
also Fig. 17 and 18), and then part 18 with the table leg 17C
ne serrer pas les vis
Vissez les pieds de table 17A et 17B (voir également fig. 17
et 18), ensuite la pièce 18 avec le pied de table 17C
Draai de schroeven niet vast an
Schroef de tafelpoten 17A en 17B er aan (zie ook afb. 17 en
18). Vervolgens deel 18 met tafelpoot 17C
skruva inte åt skruvarna hårt
Skruva på bordsbenen 17A och 17B (se även ill. 17 och 18),
därefter del 18 med bordsben 17C
¡No apriete a fondo todavía los tornillos!
Atornille las patas de la mesa 17A y 17B (vea también la
Fig. 17 y 18); luego la pieza 18 con la pieza 17C.
Schrauben Sie zuerst die kurzen Streben (20) und dann die
langen Streben (19) an die Teile 17 (kurzer Schenkel muß
nach oben zeigen)
(
nicht fest anziehen)
First fasten the short braces (20) and then long the braces
(19) to part 17; the short shank must face upwards
(
Do not tighten firmly).
Vissez d’abord les entretoises courtes (20) et ensuite les
longues (19) aux pièces 17 (le jambage court doit être orienté
vers le haut)
(
ne pas serrer)
Schroef eerst de korte steunen (20) en vervolgens de lange
steunen (19) aan de delen 17 (korte schinkel moet naar
boven wijzen)
(
niet vast aantrekken)
Skruva på de långa stöttorna (20) och de korta stöttorna
(19) på del 17 (kort skänkel måste peka uppåt)
(
skruva inte åt hårt)
Primero atornille los refuerzos transversales cortos (20) y
entonces los refuerzos transversales largos (19) a las
piezas 17 (el brazo corto deberá mirar hacia arriba).
¡No apriete a fondo!
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Atika HT 315 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Atika HT 315 in the language / languages: English, German, Dutch, French, Swedish, Spanish as an attachment in your email.

The manual is 4,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info