520137
20
Zoom out
Zoom in
Previous page
1/120
Next page
19
T
T
r
r
a
a
n
n
s
s
p
p
o
o
r
r
t
t
Power off the machine and remove the
battery before each transport.
Transport the product on the handle and with the guard
installed.
S
S
t
t
o
o
r
r
a
a
g
g
e
e
Remove the battery and store it in a dry place when the
power tool is not used.
Before a longer storage observe the following in order to
prolongate the service life of the machine and to guarantee
a smooth running operation:
- thoroughly clean the device
- treat all movable parts with an environmentally friendly
oil
L
Never use any grease!
- Store the battery at room temperature (19°C to 25°C)
and recharge it approximately once in a year.
- Protect the battery against short-circuit, e.g. by covering
the contacts with scotch tape.
Push the knife protection on the knife.
L The knife guard has two hanging eyelets that can be
used to hang up the hedge trimmer space-saving.
D
D
i
i
s
s
p
p
o
o
s
s
a
a
l
l
Give devices, accessories and packaging to an ecofriendly
recycling.
For EU countries only.
Electrical devices do not go into the domestic
rubbish.
According to the European Directive 2002/96/EC
on electrical and electronic scrap, electrical devices
that are no longer serviceable must be separately
collected and brought to a facility for an environmen-
tally compatible recycling.
Lithium ion batteries do not fall under domestic
rubbish.
According to the European Directive 2006/66/EC on
batteries and rechargeable accumulators, defective
batteries/accumulators must be recycled. Bring
batteries/accumulators, which are no longer usable,
to local collecting points or dealers.
Fully run down the lithium ion battery
T
T
r
r
a
a
n
n
s
s
p
p
o
o
r
r
t
t
The lithium ion battery has passed the test procedures accord-
ing to the guideline "Transport of dangerous goods"
ST/SG/AC.10/11/Rev.3 Part III, 38.3
The battery is safe against internal excess pressure, extreme
temperatures and short circuits or external forces.
The lithium ion content of the rechargeable battery (either as
separate part or integrated in the device) is below the required
limit and thus does not fall under national or international dan-
gerous goods regulations. However, when transporting multiple
batteries, dangerous goods regulations may be relevant and
special safety requirements must be met, e.g. identification of
the packaging.
G
G
u
u
a
a
r
r
a
a
n
n
t
t
e
e
e
e
Please observe the enclosed terms of guarantee.
P
P
o
o
s
s
s
s
i
i
b
b
l
l
e
e
f
f
a
a
u
u
l
l
t
t
s
s
Before each fault elimination:
switch off device
wait until the cutting tool comes to a stop
remove the battery
wear protective gloves
After each fault clearance, put into operation and recheck all security installations.
Fault Possible cause Remedy
Machine does not start after switch-
ing on
 Lithium ion battery run down
 Lithium ion battery defective
 ON/OFF-switch defective
 Internal fault
 Charge the lithium ion battery
 Contact the customer service
Machine does not work with full
performance
 Lithium ion battery run down
 Lithium ion battery defective
 Charge the lithium ion battery
 Contact the customer service
Machine does not cut properly  Cutting tool blunt/worn  Have the cutting tool reground or replace it
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Atika HSC560-18 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Atika HSC560-18 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 2,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info