519276

Atika ADH 204 Manual

26
Zoom out
Zoom in
Previous page
1/53
Next page
25
Possible faults
Before each fault clearance
− Switch off device
− Wait unitl the machine comes to a stop
− Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault Possible cause Remedy
Machine fails to start after
switching on or switches off during
idle running
• Power failure
• Extension cable defect
• Motor or switch defect
• Carbon brushes worn.
• Check the fuse.
• Check cable, no longer use defect cable
• Have motor or switch checked by an
approved electrician or replaced by original
spare parts
• Wenden Sie sich an eine autorisierte
Kundendienstwerkstatt oder den Hersteller
Machine is stalled during
machining.
• Dull cutting blades
• Rate of feed too high
• Motor protecting switch has tripped
• Replace or sharpen the blades.
• Continue working with slower rate of feed.
Switch motor back on after cooling ”Motor
protection”, p. 20
Workpiece is jammed during
thicknessing.
• Excessive depth of cut • Reduce depth of cut and machine workpiece
in multiple passes.
Surface unsatisfactory.
• Dull cutting blades
• Cutting blades blocked by shavings
• Erratic feeding
• Replace or sharpen the blades.
• Remove shavings.
• Feed the workpiece with constant pressure
and reduced speed.
Machined surface too rough.
• Too much moisture in the workpiece • Dry the workpiece.
Machined surface is shaky.
• Workpiece was machined against the growth
direction
• Too much material cut in a single pass
• Machine the workpiece in opposite direction.
• Machine the workpiece in multiple passes.
Chip exit blocked
• keine Absaugung angeschlossen
• Too much moisture in the wood
• Stop the machine, remove shavings and
connect the extractor.
• Use dry wood.
Workpiece advance is slow during
thicknessing.
• Resin on the thicknessing table plate
• Sluggish transport rollers
• Loose belt
• Clean the table plate and apply a thin film of
sliding wax.
• Repair the transport rollers.
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Atika ADH 204 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Atika ADH 204 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info