765259
56
Zoom out
Zoom in
Previous page
1/57
Next page
TPMS TOOL user guide
UM-36600D-U User manual ATEQ VT56 Page 57/59
Please note that in the European Union, any
warranty period less than two years shall be
increased to two years.
6. SAFETY BATTERY AND CHARGE
INFORMATION
You must read and understand these safety
instructions and warnings before using or
charging your lithium polymer batteries.
Operating environment
Remember to follow any special current
regulations any area, and always switch off
your device when its use is prohibited or when
it may cause interference or danger.
Use the device only in its normal operating
positions.
Your device and its enhancements may contain
small part. Keep them out of the reach of small
children.
About Charging
Use only the charger supplied with your device.
Use of another type of charger will result in
malfunction and/or danger.
When the red LED turns off, the charge is
complete.
About the Charger
Do not use the charger in a high moisture
environment. Never touch the charger when
your hands or feet are wet.
Allow ventilation around the charger when
using it. Do not cover the charger with paper or
other objects that will reduce cooling. Do not
use the charger while it is inside a carrying
case.
Connect the charger to a proper power source.
The voltage requirements are found on the
product case and/or packaging.
Do not use the charger if the wires become
damaged. Do not attempt to service the unit.
There are no serviceable parts inside. Replace
the unit if it is damaged or exposed to excess
moisture.
This charger is not a toy and should not be
used by children or infirm persons without
proper training or supervision.
Do not use it as a power source.
Unplug it before attempting to service or clean
it.
About the Battery
CAUTION: This unit contains an internal
Lithium Polymer battery. The battery can burst
or explode, releasing hazardous chemicals. To
reduce the risk of fire or burns, do not
disassemble, crush, pierce or dispose of the
battery or the instrument in fire or water, do not
short circuit or short the contacts with a metal
object.
Use a specified charger approved by the ATEQ
manufacturer and supplied with the device.
The tool must be returned to the factory for
battery replacement.
Opening the tool or tampering with the seal
placed on the tool, if broken will void the
warranty
Safety for Lithium Polymer battery use
NEVER leave the battery unattended during
the charging process. The device must
imperatively be placed on a non-flammable
surface during charging (ceramic platter or
metal box).
Charge the Lithium Polymer battery ONLY with
the charger provided.
NEVER use a Ni-MH (Nickel Metal Hydride)
type battery charger to charge a Lithium
Polymer battery.
If the battery begins to overheat more than
60°C (140° F), STOP IMMEDIATELY the
charge. The battery should NEVER exceed
60°C (140° F) during the charging process.
NEVER charge the battery immediately after
use and while still hot. Leave it cool down to
ambient temperature.
If you see some smoke or some liquid out of
the battery, stop the charge immediately.
Disconnect the charger and place the tool in an
isolated area for at least 15 minutes. DO NOT
USE THE BATTERY AGAIN, return the device
to your seller.
Keep a fire extinguisher for electrical fires
handy while charging the battery. In the unlikely
event that the Lithium Polymer battery will
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ateq VT 56 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ateq VT 56 in the language / languages: English as an attachment in your email.

The manual is 4,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ateq VT 56

Ateq VT 56 User Manual - German - 63 pages

Ateq VT 56 User Manual - Dutch - 63 pages

Ateq VT 56 User Manual - French - 63 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info