Manual ATAG wv9011lm (page 10 of 12) (English, German, Dutch, French)

128520

Zoom out

Zoom in

1/12

- 10 -

GENERAL

Carefully read the following important information regarding

installation safety and maintenance. Keep this information

booklet accessible for further consultations.

The appliance has been designed as a exhausting version

(external exhaust), as a filter version (internal air recycle)

cooker hood or as use in homes with centralised vacuum

system.

SAFETY PRECAUTION

1. Take care when the cooker hood is operating

simultaneously with an open fireplace or burner that

depend on the air in the environment and are supplied by

other than electrical energy, as the cooker hood removes

the air from the environment which a burner or fireplace

need for combustion.

The negative pressure in the environment must not

exceed 4 Pa (4 x 10 -5 bar).

Provide adequate ventilation in the environment for a

safe operation of the cooker hood.

Follow the local laws applicable for external air evacuation.

If the power supply cable is damaged it must be replaced

with a cable or a special assembly; both of these are

available direct from the manufacturer or from its special

technical assistance service.

2. WARNING!!

In certain circumstances electrical appliances may

be a danger hazard.

A) Do not check the status of the filters while the

cooker hood is operating

B) Do not touch the light bulbs after appliance use

C) Flambè cooking is prohibited underneath the

cooker hood

D) Avoid free flame, as it is damaging for the filters

and a fire hazard

E) Constantly check food frying to avoid that the

overheated oil may become a fire hazard

F) Disconnect the electrical plug prior to any

maintenance

This appliance conforms to the European Directive EC/

2002/96, Waste Electrical and Electronic Equipment

(WEEE). By making sure that this appliance is disposed

of in a suitable manner, the user is helping to prevent

potential damage to the environment or to public health.

The

symbol on the product or on the accompanying

paperwork indicates that the appliance should not be

treated as domestic waste, but should be delivered to a

suitable electric and electronic appliance recycling

collection point.

Follow local guidelines when disposing of waste.

For more information on the treatment, re-use and

recycling of this product, please contact your local

authority, domestic waste collection service or the shop

where the appliance was purchased.

ENGLISH

INSTALLATION INSTRUCTIONS

• Electric Connection

The appliance has been manufactured as a class II,

therefore no earth cable is necessary.

The connection to the mains is carried out as follows:

BROWN = L line

BLUE = N neutral

If not provided, connect a plug for the electrical load

indicated on the description label. Where a plug is provided,

the cooker hood must be installed in order that the plug is

easily accessible.

An omnipolar switch with a minimum aperture of 3mm

between contacts, in line with the electrical load and local

standards, must be placed between the appliance and the

network in the case of direct connection to the electrical

network.

• The appliance must be installed at a minimum height of

700 mm from an cooker stove in case of a gashob or an

electrical hob.

If a connection tube composed of two parts is used, the

upper part must be placed outside the lower part.

Do not connect the cooker hood exhaust to the same

conductor used to circulate hot air or for evacuating fumes

from other appliances generated by other than an electrical

source.

• INSTALLATION

The following instruction should be followed to carry out

the correct installation of the cooker hood.

1) Mounting of the cooker hood on the lower side of the

cupboard.

2) Selection of the version (extraction or filtration)

Mounting the cooker hood on the lower side of the cupboard.

This appliance must be fitted to a cupboard or other suitable

support. For fixing use 4 screws suitable for the cupboard,

using the hole in Fig.1. When mounting align the front of

the cooker hood to the door of the cupboard and regulate

the L wall spacer through the screws marked P (Fig. 2).

The rear of the appliance must then align with the cupboard.

• EXTRACTION THROUGH AN OUTSIDE WALL

The appliance expels the fumes through an outside wall or

a duct. It is necessary to buy a telescopic pipe in

accordance with the standards in use (not inflammable

with diameter 150mm) and connect it to flange F (Fig. 3).

• RECIRCULATION

To transform the cooker hood from the extraction version

to the re circulating one ask your supplier for an activated

carbon filter. The activated carbon filter cleans the air of

the room. This filter is not washable or re-usable and must

be substituted at least every 4 months. Saturation of the

activated charcoal depends on how often the appliance is

used, the type of kitchen and how regularly the grease

filter is cleaned. The filter must be fitted to the extracting

group cooker hood in the centre of the fan grille by twisting

it by 90 degrees until it is gripped securely. For this

operation remove the grill G (Fig. 2). The clean air is

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of ATAG wv9011lm in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,15 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

ATAG wv9011lm Manual

Product: