557046
55
Zoom out
Zoom in
Previous page
1/72
Next page
EN 13
Montage
Drilling the support surface and fitting the Hood
The hood can be fitted directly on the lower surface of the wall units
(at minimum 650 mm above the cooker top) using the snap-on Side
Supports.
Make an opening on the lower surface of the wall unit, as indicated.
• Screw the closing profile 20 onto the rear part of the hood, using
the screws 12e (2.9 x 12.7) provided.
Open the glass panel.
Remove the metal grease filters one by one by turning the hooks
provided.
Close the glass again.
Insert the hood until the snap-on side supports click into place.
Open the glass panel.
Lock in position by tightening the screws Vf from underneath the
hood.
437
255
Vf
INSTALLATION
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG WV6211NM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG WV6211NM in the language / languages: English, German, Dutch, Danish, French as an attachment in your email.

The manual is 4,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info