557040
65
Zoom out
Zoom in
Previous page
1/66
Next page
EN 17
INSTALLATION
Montage
Building in the extractor hood
Remove the edge-extractor panel:
- Flip the edge-extractor panel downwards.
- Release the latch cables by turning the bayonet catch 180
degrees.
- Disconnect the connectors from the electricity cable.
Remove the edge-extractor panel from the extractor hood.
Put the plug of the extractor hood in the socket.
Connect the 7-pole connector to the 7-pole connector of the
external motor (WU11..PX/WU15..PX).
Position the extractor hood in the hole and slide the 4 sliding pieces
outwards from inside the hood. The extractor hood should remain
hanging.
Secure the extractor hood to the joists or to the ceiling using the
screws provided and the holes intended for this purpose.
Refit the edge-extractor panel.
Do not forget to reconnect the electric cable connectors and to
pull the cables taut so they do not get caught in the hinge.
65


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG WU1150PX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG WU1150PX in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info