692595
56
Zoom out
Zoom in
Previous page
1/60
Next page
EN 14
INSTALLATION
Montage
Preparing the hole
Determine the position of the hole in the ceiling or in the chimney
with respect to the cooking plate.
The extractor hood is fit with a temporary suspension system with
sliding pieces to make mounting easier. To use this system, the
hole should be fit with a suspension edge for temporary hanging
(height: maximum 40 mm; see diagram).
Note: the mounting must be sturdy enough to bear the weight of the
extractor hood at 4 points.
It is preferable to provide the ceiling/chimney breast with a joisted
layer to which the extractor hood can be attached using the four
screws (see picture). If this is not possible, the extractor hood can
be mounted directly onto the ceiling. Account for the position of the
fastening holes (see hole pattern on page 12/13).
For upward extraction, the joists should preferably run parallel with the
short sides. When using the optional flat duct system, the joists must
run parallel with the direction of extraction.
max. 40 mm
235 mm
284 mm
min. 36 mm
ceiling/chimney
suspension edge sliding piece
joisted layer
extractor hood
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG WU1111PMM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG WU1111PMM in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info