634355
61
Zoom out
Zoom in
Previous page
1/66
Next page
EN 13
Wall drilling and bracket fixing
min.550
min.650
Wall marking:
Draw a vertical line on the supporting wall up to the ceiling, or as
high as practical, at the centre of the area in which the hood will be
installed.
Draw a horizontal reference line at 650 mm above the hob.
Place bracket 7.2.1 on the wall as shown about 1-2 mm from the
ceiling or upper limit aligning the centre (notch) with the vertical
reference line.
Mark the centres of the holes on wall.
Place bracket 7.2.1 on the wall as shown at X mm below the first
bracket (X = height of the upper chimney section supplied), aligning
the centre (notch) with the vertical line.
Mark the centres of the holes on wall.
Mark a reference point as indicated at 116 mm from the vertical line
and 305 mm above the horizontal reference line.
Repeat this operation on the other side.
Drill ø 8 mm holes at all the centre points marked.
Insert the wall plugs 11 in the holes.
Install the lower bracket 7.2.1 using the 12a screws (4,2 x 44,4).
Install the upper bracket 7.2.1 and the air outlet connection support
7.3 together using the 2 screws 12a (4,2 x 44,4).
Insert the two screws 12a (4,2 x 44,4) in the hood body fixing holes,
leaving a gap of 5-6 mm between the wall and the head of the
screw.
INSTALLATION
61


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG WS9211EM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG WS9211EM in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info